Made for all iPod® models including iPod® nano, and iPod® mini
OWNER’S MANUAL
iR30
Visit our web site at www.emersonradio.com
iR30_5_101206.p6513/10/2006, 13:4418
!
CAUTION
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN
EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES
CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE
OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The lightning flash with arrowhead symbol, within an equilateral triangle is intended to
alert the user to the presence
of uninsulated ‘dangerous voltage’
within the product’s enclosure
that may be of sufficient
magnitude to constitute a risk
of electric shock to persons.
WARNING: TO REDUCE THE
RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER
(OR BACK), NO U SER
SERVICEABLE PARTS INSIDE
REFER SERVICING TO
Q U A LI F IE D S E R VI C E
PERSONNEL.
The exclamation point within
an equilateral triangle is intended to alert the user to
the presence of important
operating and maintenance
(servicing) instructions in
the literature accompanying the appliance.
The Caution Marking maybe located at the bottom enclosure of the apparatus.
IMPORTANT SAFETY INSTRUCTIONS
1.) Read these instructions. Keep these instructions. Follow all instructions. Heed all warnings.
2.) Do not use this apparatus near water.
3.) Clean only with dry cloth.
4.) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
5.) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
6.) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding type plug has two blades and a third grounding
prong. The wide blade or the third prong is provided for your safety. If the provided plug does not
fit into your outlet, consult an electrician for replacement of the obsolete outlet.
7.) Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
8.) Only use attachments / accessories specified by the manufacturer.
9.) Unplug this apparatus during lightning storms or when unused for long periods of time.
10.) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has
been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
11.) This appliance shall not be exposed to dripping or splashing water and no object filled with liquids
such as vases shall be placed on the apparatus.
12.) Use only with the cart, stand, tripod, bracket, or table specified by the
manufacturer, or sold with the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to avoid injury from tip-over.
13.) Do not overload wall outlet. Use only power source as indicated.
14.) Use replacement parts as specified by the manufacturer.
15.) The product may be mounted to a wall only if recommended by the manufacturer.
16.) Upon completion of any service or repairs to this product, ask the service technician to perform
safety checks.
1
iR30_5_101206.p6513/10/2006, 13:441
Congratulations!
You are now the owner of an iTone™ AM/FM Table Radio with iPod® Docking
Station by Emerson Research. This compact unit will provide exceptional
sound quality from your favorite AM and FM stations while occupying an
absolute minimum of space. In addition, the top-mounted iPod® docking
station allows you to listen to your iPod® through the speaker of this system
when using the ear-buds is not convenient. Adapters for all “dockable”
iPod®s are included. And the iPod® battery is automatically recharged while
the iPod® is resting in the dock and the radio is not in use. We have even
included an Auxiliary Input Jack on the back panel that allows you to connect
and listen to other MP3 players or personal CD players through the speaker
of this radio.
Please read this Owner’s Manual carefully and completely. If, after reviewing
the instructions, you experience any problems with the set-up or operation
of this product please call the Emerson Customer Service Hotline, toll-free
at 1-800-898-9020. The hours of operation are 9:00 AM to 5:00 PM Central
Time, Monday through Friday.
The Serial Number of your unit is located on a label on the back panel.
Please write the Serial Number in the space provided on the warranty
page of this manual. You may be asked for the serial number of your unit
when calling for customer service.
®
iPod
is a trademark of Apple Computer Inc., registered in the U.S. and other countries.
2
iR30_5_101206.p6513/10/2006, 13:442
IMPORTANT NOTES
• Avoid installing this unit in places
exposed to direct sunlight or close to
heat radiating appliances such as
electric heaters, on top of other stereo
equipment that radiates too much
heat, places lacking ventilation or
dusty areas, places subject to
constant vibration and/or humid or
moist areas.
• Operate controls and switches as
described in the manual.
• Before turning on the power, make
certain that the AC power cord is
properly installed.
• When moving the set, be sure to first
disconnect the AC power cord.
FCC Information
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection agains t harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
3
iR30_5_101206.p6513/10/2006, 13:443
PREPARATION FOR USE
• The carton contains the radio with iPod® docking station, 5 different plastic
iPod® adapters to use with older iPod® models, and an iPod® support bracket
to be mounted in the docking station.
iPod® Support Bracket
Main Unit
Please make sure that all parts are removed from the carton and that nothing
is accidentally discarded with the packing materials. We recommend that you
save the carton and packing materials if possible in the even that the unit ever
needs to be returned for service.
• Place the unit on a level, stable surface, convenient to an AC outlet, and away
from direct sunlight or sources of excess heat, moisture, humidity, dust, or
strong magnetic fields.
• Unwind the AC power cord and the external FM wire antenna and extend both
to their full length. Connect the AC power cord to your 120V 60Hz household
outlet.
4
iR30_5_101206.p6513/10/2006, 13:444
Power Source
AC Outlet
This system is designed to operate on 120V AC 60Hz house current only.
Connecting this system to any other power source may cause damage to the
system and such damage is not covered by your warranty.
NOTE: The system has a polarized AC plug with one wide blade and one
narrow blade. The plug will only fit into matching polarized AC outlets.
This is a safety feature to reduce the possibility
of electric shock. If the plug will not fit in your
AC outlet, you probably have an outdated nonpolarized outlet. You should have your outdated
outlet changed by a qualified, licens ed
electrician. Do not file the wide blade on the
plug, or use an adapter to make the plug fit into
your outlet. This defeats the safety feature and
could expose you to electric shock.
AC Plug
Protect Your Furniture
This model is equipped with non-skid rubber 'feet' to prevent the product from
moving when you operate the controls. These 'feet' are made from non-migrating
rubber material specially formulated to avoid leaving any marks or stains on your
furniture. However certain types of oil based furniture polishes, wood preservatives,
or c leaning sprays may cause the rubber 'feet' to soften, and leave marks or a
rubber residue on the furniture. To prevent any damage to your furniture we strongly
recommend that you purchase small self-adhesive felt pads, available at hardware
stores and home improvement centers everywhere, and apply these pads to the
bottom of the rubber 'feet' before you place the product on fine wooden furniture.
5
iR30_5_101206.p6513/10/2006, 13:445
Loading...
+ 12 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.