Emerson Edco H Brochures and Data Sheets

Features

■ Primary and secondary protection

■ UL 497 and UL 497A Listed*

■ Patent pending UHS technology

■ Silicon foldback technology

■ Auto reset fusing (PTCs)

■ Surge and sneak current protection

■ 5 year warranty

Edco™H Series

Telecom/Punch Block
Primary/Secondary Protection

Power Switching & Controls
For Business-Critical Continuity

TM

The Edco H Series modules are ultra high speed fused solid state dual listed
Primary (UL 497) and Secondary (UL 497A) protectors for KEY/PABX systems.
The units are available in two different clamping voltages. The Edco H Series is
constructed with solid state silicon foldback technology, polyswitch resettable
fuses — PTCs — and failure fuses. The protective elements switch from the
normal high-impedance state to a low-impedance state upon a detection of a
surge, then switch back to high impedance after the surge has passed. The Edco
H Series single pair modules fit onto a standard Edco MI-50 split block and
replace bridging clips. In addition, these modules require the Edco MGB Ground
Rail for each Edco MI-50 block used.

Operating Voltage 48, 200 VDC

Clamping Voltage (HDE) 65

Primary Breakdown Range (HCO) 202 -625 VDC

Operating Current 0.15A

Peak Surge Current 160A (10 x 1000 T & R to Gnd)

Frequency Range 0 to 20MHz

Insertion Loss < 0.1 dB at 20MHz

SPD Technology Silicon Breakover Device w/Series PTC

Connection Type Clip

Operating Temperature -40°C to +85°C

Dimensions (Inches) 1.25H x 0.4W x 2.8L

Weight 1 oz

Warranty 5 years

Digital Extensions HDE

Central Office/Trunks HCO

General Technical Specifications

Ordering Information

DO NOT daisy chain grounds. NOT intended for
shield termination. Install ground in accordance
with all applicable codes.

* The protector is to be used in a Listed enclosure

when used as a Primary protector and may or
may not be used in a Listed enclosure when
used as a Secondary protector.

**#6 AWG wire to building approved ground -

keep short. See UL 497, paragraph 7.2.2 for
more information

Installation

IO-50134 9/13 Rev. 2 Printed in USA

Business-Critical Continuity, Emerson Network Power and the Emerson Network Power
logo are trademarks and service marks of Emerson Electric Co. ©2013 Emerson Electric Co.

www.emersonnetworkpower.com/surge

Emerson Network Power Contact information

Headquarters

Surge Protection
100 Emerson Parkway
Binghamton, New York 13905
T: [phone]
T: [phone]
F: [phone]
E: [e-mail]

AC Power

Connectivity

DC Power

Embedded Computing

Embedded Power

Industrial Power

Infrastructure Management & Monitoring

Outside Plant

Thermal Management

Racks & Integrated Cabinets

Power Switching & Controls

Services

Emerson Network Power.

The global leader in enabling

Business-Critical Continuity

TM

.

Installation should be performed by qualified personnel ONLY and in compliance with NEC Article 800.30 for primiary
protection and NEC article 800.32 for secondary protecton.

**