Emergi-Lite EF40 User Manual

EF39 Nema-4X Die-cast remote heads

Parts List

1. Screw cover (2)

2. Lens screw (2)

3. Lens

4. O-ring (2)

5. Junction box screw (4
required) (not provided)

6. Lamp assembly (1 or 2)

7. Back plate

8. Gasket

9. Weather proof junction
box (not provided).

WARNING:

Risk of Shock.

Disconnect Power before Installation.

Figure 1

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precauti ons sh oul d always be
followed including the following:

READ AND FOLLOW ALL SAFETY
INSTRUCTIONS

1. All servicing should be performed by qualified service personnel.

2. Do not mount near gas or electric heaters.

3. Equipment should be mounted in locations and at heights where it

will not readily be subjected to tampering by unauthorized personnel.

4. The use of accessory equipment not recommended by the manufac-

turer may cause an unsafe condition.

5. Do not use this equipment for other than intended use.

EF39 Nema-4X Die-cast remote heads

SAVE THESE INSTRUCTIONS

Installation instructions

1. Turn off power.

2. Remove the lens.

3. Install the gasket (8) on the back plate.

4. Connect the lamp wires to the emergency circuit using wire nuts. For
double lamp assembly fixtures, lamps should be connected in parallel,
not in series. Refer to lamp voltage indicated on the unit.

5. Fasten the back plate with 4 screws to either a nema 4X rated junction
box or directly to a recessed junction box making sure the unit is
properly sealed all around (gasket will not guarantee an adequate seal
on all surfaces).

IMPORTANT: The junction box must be Nema 4X rated for the unit to
retain a Nema 4X rating. Plugs must be properly sealed with a sealing
compound.

6. Adjust the lamp assemblies:

- Rotation: hold the lamp assembly and turn it to either side.

- Tilting: hold the lamp assembly and tilt it up or down.

7. Secure the lens to the back plate with the screws provided.
ATTENTION: All lens and junction box screws must be tightened to a

torque of 15inlb.
The screw covers can be installed to prevent the accumulation of

debris on the screws, as required by NSF.

8. Turn on power and check the operation of your lighting fixture.

Lamps replacement

Refer to the relamping label located near the lamp holder or the
recommended maximum wattage. Do not exceed recommended wattage.

Emergi-Lite Tel: [phone] Fax: [phone] www.emergi-lite.com

03/14 750.1205 Rev . D

1/1