EMCT RP 100 6 Instruction Manual

Zertifizierungsstelle
SIBE Schweiz

Instruction manual for
RP 100 6 EMCT Electronic Test Buzzer

1

Battery box

2

Test buzzer

3

Measuring line

4

Test terminal

5

Pluggable test terminal

Table of contents

1 Introduction ........................... 1

1.1 Application .............................. 1

1.2 Remarks ................................. 1

1.3 Scope of delivery .................... 2

2 Safety instructions ................ 2

3 Instruction ............................. 2

3.1 Bringing into service ............... 2

3.2 Continuity check ..................... 2

4 Maintenance .......................... 3

4.1 Battery change ....................... 3

5 Technical data ....................... 3

EC Declaration of Conformity .............. 4

1 Introduction

1.1 Application

The RP 100 6 Electronic Test Buzzer can be used for the ohmic continuity check of switches,
lines, circuits, fuses, lamps, diodes, transistors, polarity tests, coils, resistors, transformers,
relays and contractors. Resistance test range is between 0 and 1 kΩ.

 Protected against external voltage
 Test range: low or high ohmic
 Test terminal pluggable
 Red plastic housing shockproof

1.2 Remarks

In this instruction manual noted remarks:

Warning:

Warns of a danger which could bring injuries.

Indication:

Has to be considered!

Important:

Important information!

1 2 3

5

4

RP 100 6 Bedienungsanleitung eng Seite 2 von 4

1.3 Scope of delivery

Included in delivery is:
1x RP 100 6 EMCT Electronic Test Buzzer

1x pluggable test terminal
1x instruction manual

2 Safety instructions

The remarks noted in this instruction manual are inevitable for a save application of
the test buzzer. You are advised not to use the test buzzer before reading the safety
instructions. Disobeying the instructions can result in injury!

The test object has to be in a tensionless state.

The test buzzer is not qualified to be used in energized objects.

The measuring lines and test terminals may only be touched at the intended
handles.

The test buzzer may only be used in the denoted test ranges.

Before opening the battery box the test buzzer has to be disconnected from all the
measuring circuits.

For use by competent persons only. Anyone using this Product should be
knowledgeable and trained about the risks involved with measuring voltage,
especially in an industrial setting, and the importance of taking safety precautions
and of testing the Product before and after using it to ensure that it is in good
working condition.

The test buzzer has to be placed out of children’s reach.

3 Instruction

3.1 Bringing into service

Before bringing the test buzzer into service you have to insert a 9 V block battery (IEC 6 F

22). Proceed as indicated in 4.1.

3.2 Continuity check

The test buzzer permits a simple and fast continuity check by recognizing a closed circuit
and giving off an acoustic signal. Thanks to that one doesn’t have to take a look at the test
buzzer during the check. The acoustic signals sound different when there is a different
resistance value.

Proceed as indicated below:

 Connect the test terminals with the testing object at two points you want to check.
 If there is continuity you will hear the acoustic signal.