EmberGlo ES5M Service Manual

Service Bulletin

ES 5M Series Steamer
Pump Handle Replacement Installation Kit # 1400-20

CAUTION: Read and understand this service bulletin thoroughly before starting. Only
a trained, experienced service technician should attempt this service procedure.

Kit # 1400-20 contains the following:
Item # Part # Description Qty
1 1400-25 Pump Handle Weldment 1

1

2 1400-30 Pin Punch 1
3 Hardware 5/32” x 7/8” long Spring Pin 1
4 8699-25 Sleeve Tube (1″) 1
5 8471-62 Service Bulletin 1

ITEMS NEEDED FOR REPLACEMENT OF HANDLE
Phillips screwdriver
Hammer (brass faced or soft faced hammer recommended)

CAUTION: BEFORE ATTEMPTING SERVICE, SHUT
OFF ALL POWER TO THE STEAMER AND ALLOW THE
STEAMER TO COOL. PUT ON SAFETY GLASSES.

INSTRUCTIONS FOR REPLACEMENT OF HANDLE

1. Unplug the steamer and remove the two screws from front
control panel. (Fig. 1)

2. Release the spring tension by removing the spring ends
from the spring seats. (Fig 4)

3. Remove pin from handle shaft using supplied pin punch.
with a brass or soft faced hammer. (Fig. 3) Discard old pin.

4. Pull handle out.

5. Insert the new handle through the crank assembly and
the coils of the spring.

Figure 3

Pin

Spring Location
(Behind Crank
Assembly)

Front Control
Panel Screw

Figure 1

Front Control
Panel Screw

4

Figure 2

3

Sleeve Tube Assembly

2

6. With the handle in the correct orientation position (see
Fig 3), align the hole in the handle shaft to the crank
assembly hole.

7. Place plastic sleeve on punch tip approximately 1/2 the
way on the shaft. Insert and seat spring pin into the
plastic sleeve to hold the pin during installation

8. Insert new pin through the handle shaft hole and crank
assembly hole. (Fig 3)

9. Re-set the tension in the spring by compressing the
spring ends and position them in the correct groves on
the spring seats. (Fig 4)

10. Replace the control panel and tighten the two screws. (Fig 1)

11. Re-connect the power supply to the steamer.

Spring Seat
(Back)

Spring
Coil

Shaft of
Handle

Spring Ends

Spring Seat
(Front)

Figure 4

EmberGlo

A Div of Midco® International Inc.

4140 West Victoria Street
Chicago, Illinois 60646
toll free 866.705.0515
tel [phone]
fax [phone]
web www.emberglo.com
e-mail [e-mail]

Spring and Spring Seats - Top View

AVOID ERROR IN PARTS SELECTION. When ordering use complete EmberGlo Part Number
and Description. Furnish the Product Model Number, Bill of Material Number and Serial Number
(if available) from the specifi cation plate found on the product.

IMPORTANT: Availability of parts as well as specifi cations are subject to change without notice.
Please consult factory for item availability.

SAFETY INFORMATION TERMS: The following terms are used to identify hazards, safety precaution of
special notations and have standard meanings throughout this manual. They are printed in all capital letters
using a bold type face as shown below, and preceded by the exclamation mark symbol. When you see the
safety alert symbol and one of the safety information terms as shown below, be aware of the hazard potential.
DANGER: Identifi es the most serious hazards which will result in severe personal injury or
death.
WARNING: Signifi es a hazard that could result in personal injury or death.
CAUTION: Identifi es unsafe practices which would result in minor personal injury or product and
property damage.

711

8471 62

Quality Designed for Proven Performance

Printed in USA