Embelin Remuc-2-AC Installer's Manual

Operating voltage

+9V...32V

Operating temperature

-30...+80C

Current consumption on stand-by

< 30mA (12V)

Operating range of the heat sensor

-55...+125C

PARTS OF INSTALLATION

 REMUC-2-AC controller
 External antenna
 Cables needed for installation
 GPS/GLONASS receiver (only Remuc PLUS)

 Illuminated usage button

ELECTRICAL FEATURES

INSTALLER GUIDE

IMPORTANT INFORMATION

WARNING! Familiarize yourself with usage, service and safety instructions supplied with

the device that is controlled using REMUC.

CONTROLLER MUST BE INSTALLED SO THAT THE INSTALLATION NEVER

EXCEEDS GIVEN VOLTAGE AND CURRENT INPUT LIMITS. CURRENT INPUT MUST
BE GUARDED WITH A 5A FUSE

PIN code for the SIM card must be one of the following: ”1234”, ”0000” or the PIN code

query must be disabled completely

If any other SIM card is used than the one included in the package, SIM card functionality

must be verified with a mobile phone before installation.

CONNECTING REMUC USAGE BUTTON

Installer should proceed with caution when
assembling usage button connector. Wire contact
going in the plug must be in correct orientation and
of correct color, otherwise breakage may occur.

v1.2 © 2014 Embelin Ltd. , all rights reserved

CONNECTOR SCHEMATICS

RC2A

Cable with full wiring

RC2AE

Basic installation cable (Eberspächer)

RC2AL

Basic installation cable (Webasto)

Cable

RC2A RC2AE RC2AL

1

BLACK

Ground

x x

2

ORANGE

WBC x 3

NC

4

NC 5

GRAY

Button

x x x

6

GRAY

x x x

7

GRAY

Input 1

+0V...+24V
(>1V = active)

8

VIOLET

Input 2

+0V...+24V
(>1V = active)

9

RED

Vin

+12V…+24V
(5A fuse needed)

10

YELLOW

Output1 (+)
(heater control)

Output 0,5A (no fuse)
Vin voltage (PIN 9)

11

WHITE

Output2 (+)
(Fan control)

Output 0,5A (no fuse)
Vin voltage (PIN 9)

12

GREEN

Button

x x x

13

BROWN

Button

x x x

14

BROWN

Temp sensor

x x x

15

NC

16

BLACK

Ground

x

 Three different installation cables are available:

PIN

COLOUR FUNCTION

NO

x
x
x x
x x
x

INFORMATION

RESETTING REMUC WITH USAGE BUTTON

RESET / RESTART

1. Press and hold usage button at least 10 seconds. Release button.

2. Status light on usage button blinks for 10 seconds. After this controller is reset.

3. REMUC is ready for use when blinking stops.

FACTORY RESET

1. Press and hold usage button for at least 10 seconds. R el e ase but t o n.

2. Status light on usage button blinks for 10 seconds. During this time press button

shortly 3 times.

3. Controller will be reset to factory settings.

4. REMUC is ready for use when blinking stops.

STATUS LIGHTS AND CONNECTIONS

 Controller status LED (orange)

o Blinks: Controller is restarting
o Lit: Controller is powered and connected to a network

 GSM modem status LED (red)

o Blinks in 1 s intervals: Searching network or SIM card is not inserted or it’s locked.
o Blinks in 3s intervals: Connected to a network

 If controller status LED does not switch to continuously lit mode after 5 minutes from restart,

check SIM card PIN code. PIN code MUST be “1234”, “0000” or disabled. W ipe the SIM
card contacts clean.