E-matic PM460LED User Manual
6x27mm
OFF
1
9
ON
4x30mm
3x 3x
mm
108mm
2
3
φ6mm
30mm
?214
4
5
7 8
6
360
°
3-4m
Max.6m
0
Max.6m
360
°
Max.6m
CEILING LIGHT WITH MICROWAVE
SENSOR
MODEL: PM460LED
We are delighted that you have purchased this
MICROWAVE Light. This light is suitable for indoor
use only. Please read this instruction manual before
installation and retain for future reference.
IMPORTANT: Never modify the unit, there are no
user serviceable parts inside. Not suitable for use
with dimmer switches. Install in accordance with IEC
Wiring Regulations.
THE LIGHT SHOULD BE INSTALLED BY A
QUALIFIED ELECTRICIAN.
POSITIONING THE LIGHT
When selecting the mounting position, take into
account the following points:
1. The sensor is designed for optimum performance
when mounted at a height of above 2.5 to 4 meters
(see Figure )
2. Avoid pointing at or positioning close to heat sources
such as heaters or heat extraction units, which may
cause false triggering.
3. Avoid pointing at bright lights as the sensor will not function when you
set Lux control level to dark
4. Avoid mounting at strong electromagnetic disturbance, i.e. near
electrical motor or fluorescent lamp ballast.
INSTALLING THE LIGHT
Before commencing any electrical work, ensure the mains supply is
isolated by switching off and removing the relevant fuse. (See Figure
2)
1. Remove the glass shade.
2. Use the back metal disk to mark the position of screw onto ceiling
surface. Using a bit, drill the wall to a depth of about 3cm. Fit the
rawl-plugs supplied.
3. Bring mains wiring through and fix back metal disk to ceiling surface
using screws. Connect mains wiring to the terminal block.
4. Re-fit the Glass shade.
After finishing the installation operation, you can adjust the working state of
the MICROWAVE SENSOR
TECHNICAL DETAILS:
Voltage: 220-240 V~ 50 Hz
Wattage: 40×0.5W LED
Detection range: 360° and Max.6meters radius (see Figure )
Delay time: 10s to 10 min. adjustable
Lux control level: Daylight to Night adjustable
IP: 44
Due to our policy of continuous improvement we reserve the right to
change specification without prior notice.
Errors and omissions excepted. These instructions have been carefully
checked prior to publication. However, no responsibility can be accepted
by E-Matic for any misinterpretation of these instructions.
Warning:
Do not dispose of electrical appliances as unsorted municipal waste, use
separate collection facilities.
Contact your local government for information regarding the collection
systems available.
If electrical appliances are disposed of in landfills or dumps, hazardous
substances can leak into the groundwater and get into the food chain,
damaging your health and well-being.
E-Matic Energy Management Solution
E-Matic Energy Management Solutions
10 Sandersons Way, Marton,
Blackpool, FY4 4NB
Tel: 01253 791888, Fax: 01253 791887
Email: enquiries.ematic@adivision.co.uk
Web: www.ematic.co.uk
1 2 3 4 5 6
<200LUX 0 0 x x x x
<60LUX 0 1 x x x x
<20LUX 1 0 x x x x
LUX
<5LUX 1 1 x x x x
6m x x 0 0 x x
4.5m x x 0 1 x x
3m x x 1 0 x x
SENS
1.5m x x 1 1 x x
10s x x x x 0 0
1min x x x x 0 1
4min x x x x 1 0
TIME
10min x x x x 1 1
1=ON 0=OFF x=ON or OFF
Loading...