This manual contains important safety measures and information about how to correctly use
avoid an accident, make sure you carefully read this manual before operation.
Many services and applications offered through this device may be provided by third parties. Before you use,
link to or download a service provided by a third party, or an application such as a location-based GPS-type
service, chat room, marketplace or social network from your device, you should review the terms of such
service or application and applicable privacy policy. Personal information you submit may be read, collected
or used by the service or application provider and/or other users of those forums. Ematic is not responsible
any information, content or services you access, download, or use from the Internet. You are responsible for
maintaining virus and other Internet security protections when accessing
This manual may not reflect your actual device’s operation. All information is subject to change
without prior notification. Please follow your actual device’s operational procedures.
the internet.
device. To
this
for
Table of Contents
Section 1: Getting Started .................................. 1
Understanding this User Manual ........................1
Special Text .......................................................1
Section 7: Warranty Information ....................... 19
Section 1: Getting Started
This section helps you to quickly start using your
device.
Understanding this User Manual
This manual gives operation instructions
according to the default factory settings. If you
change the default settings, navigation steps
may be different.
Unless otherwise specified, all instruction in this
manual assumes starting from the HOME screen.
To get to the HOME screen, the device may first
need to be unlocked.
Special Text
Notes, Cautions, and Warnings
NOTE: Indicates important information
that helps you make better use of your
device.
CAUTION: Indicates potential damage to
hardware or loss of data if instructions
are not followed.
WARNING: Indicates a potential for
property damage, personal injury, or
death.
Getting Started | 1
Battery Management
This device is powered by a rechargeable battery
and is designed and manufactured to be used
and recharged frequently. As with all batteries,
the capacity of the battery reduces each time it is
charged/depleted. However, you can prolong the
battery’s lifetime by following the suggestions
below:
• Use your Tablet at least once a week.
• Charge the battery regularly and fully.
• Never leave the battery fully discharged for
a long period of time.
•Always keep the device and the battery
away from heat.
The battery is not fully charged out of the box, so
it is recommended the battery be charged for at
least 4 hours before starting to use the device.
NOTE: The first two times the battery is
charged, it may take as long as 6 hours to
fully activate the battery.
2 | Getting Started
Battery Indicator
The battery icon in the System Bar shows battery
power level.
In the event the battery becomes low on power,
the follow will occur:
• The battery icon will show no power
• Device will power OFF automatically
• Operation buttons will not respond
• Red signal appears in right corner of device
Should any of the above conditions occur,
charge the battery before attempting to use the
device.
Charging the battery
1 Plug the power adapter into an electrical
wall outlet.
2 Connect the power adapter to the device’s
power interface port to fully charge the
battery before use (approximately 4 hours).
a. While charging, the battery indicator
light in the system bar will fill and then
drain with an image of a lightning bolt.
b. When fully charged, the battery
indicator light is green.
NOTE: The device can be used while the
battery is charging, although the charging
time is longer when operating and
charging at the same time.
Turning the Device ON/OFF
To turn the device ON:
1 Press and hold the POWER button for 3
seconds.
2 Release the POWER button.
NOTE: It may take a few minutes for the
system to start-up. Wait before proceeding.
To turn the device OFF:
1 Press and hold the POWER button until the
option to “Power OFF” is displayed.
2 Tap “Power OFF”.
3 Tap “OK”.
Getting Started | 3
Micro SD Card
Installing a Micro SD Card
1 Carefully insert a Micro SD card until it
clicks into place.
4 | Getting Started
Removing an Micro SD Card
CAUTION: Use care to properly remove
the Micro SD Card. Any sudden removal
may cause damage to the device or to
data stored on the Micro SD Card.
1 Confirm all files or programs running from
the Micro SD Card have been closed.
2 Carefully press the Micro SD Card to cause
it to automatically eject.
3 Remove the Micro SD Card from the slot.
Loading...
+ 17 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.