Elysee J12 User Manual

ELYSEE J12 Multi-Function Jump-Starter

ELYSEE J12 Multi-Function Jump-Starter

Manual

Package Contents:

• Jump-Starter • Jumper cable with smart clamps

• Micro USB adapter cable with sync function • Cigarette Lighter Adapter

Technical Specifi cations:

Capacity: 12000mAh/44.40Wh
Start Current: 200A
Peak Current: 400A
Charging Port Output: 5V – 2.1A (min. 80mA)
Input: 5V – 2.1A (max.)
Size: 163 x 76 x 32 mm (L x W x H)
Size with pocket: 210 x 130 x 80 mm
Net Weight: 430g/15.2oz

j Power button
k LED fl ash light
l 5V 2.1A Input
m 5V 2.1A Output
n Charging indicator
o 5V 2.1A Output
p Output for jumper wire
q Compass

Note: Please be advised that this gadget will not charge the devices with input currents lower than 80mA,
including some Bluetooth and GPS devices.

How to Charge This Gadgets

1. Plug the Micro USB cable into the gadget input port.

2. Insert the remaining end of the USB cable into (a) an AC adapter connected to the wall socket or (b) a char­ging computer USB port or (c) a car adaptor socket of cigarette lighter.℃Both AC adapter and Car adaptor are
optional device℃

3. The battery will automatically begin to charge and will turn off when fully charged.

LED Indicator Display While Charging the Gadget

Indicator LED-Display Battery Capacity

First light blinking < 25%

First light on,second light blinking 25 - 49%

Two lights on, third light blinking 50 - 74%

Three lights on, fourth light blinking 75 - 99%

Four lights on 100%

USB Adapter Charging Speed

Adapter Current Output Charging Time

5V/2.1A about 5 hours

5V/1.5A 6 - 7 hours

5V/1A 10 - 11 hours

5V/0.5A about 24 hours

How long will the power of battery of this
gadget remain?

6-12 months, however, we suggest you recharge it
every other 3 months.

How many times can this gadget on a full
charge to start the vehicle?

Approx. 20 times.

Vehicle Instruction

1. Make sure that the number of indicators is not less than 3 ones

2. Connect the RED clamp to the vehicle‘s battery positive (+) terminal and connect the BL ACK clamp to the
vehicle‘s battery negative (-) terminal.

3. Plug the cord of jumper cable into the jump start socket.

4. Check indicator light on clamps , Green light means ready to go , then start the vehicle
(otherwise please check the connection).

Warning:

At extremely low volt of your batterie, it may happen that the display of the LED does
not turn green. Then please check the bottom of the black electronic box. Press
with a paper clip the „boost button“.

5. When the vehicle is started, remove the jumper cable from this gadget and
disconnect RED and B LACK clamps to vehicle battery.

6. Leave the vehicle‘s engine running.

pointed

Object

Boost-

button

Charging Cell Phone or Tablet Instruction

1. Plug the switch cable to USB 5V/2.1A output port. (

2. Select appropriate connector for your cell phone or tablet and

moro

)

connect it to any of them , this gadget can identify and charge the
electronic automatically . The indicators will be on when the device
is charging

3. The LED lamps are lit during the charging process.

LED-Lampe mit SOS-Funktion

1. Press the switch 3 seconds to turn on/off the LED flash light.

2. There are 3 modes of LED light: Normal light, Strobe, SOS, which can be shift in turns
by pressing the switch .

3. Press the switch 3 seconds to turn off the LED flash light no matter you are in any mode.

Usage Notes & Warning:

• The quick-starter to start vehicles with engine capacity up to 4 liters.

• This is possible even without a car battery or battery completely defective.

• Always make sure the blue plug of cable connect with the jump start socket tight in this product before jumping
start the vehicle. Otherwise, it will affect the results, even causing the melt of the blue plug.

• Always check if the jumper clamps are well connected.

• DO NOT jump start again after 3 attempts. Otherwise, it will damage the host.
Check your vehicle if has other trouble.

• Please keep this gadget about 30 feet away from your vehicle when using the compass

Warning!

• Do not modify or disassemble this product.

• Always take care when using this product.

• Do not use as a toy.

• Do not allow this product to become wet. Do not immerse this product in water .

• Do not store in locations where the temperature may exceed 70°C. The advised storage temperature
is -10°C℃ to 45°C. Under extreme conditions, battery leakage may occur.

• Do not operate this product in explosive atmospheres, such as in the presence of flammable liquids,
gases or dust.

Warranty

Our company provides customers with a warranty of 12 months from the date of the purchase. We may not cover
the damage caused by misusing the product.

Distribution: ELYSEE GmbH · Heerdter Lohweg 212 · 40549 Düsseldorf · [e-mail] · Tel. [phone]