ELVA 1 PPC-1000-E Users Manual

x Obstacles on the signal propagation line. Remove them or change the position of the

radio.

x Alignment disturbance. Re-align the stations.
x Response transmitter failure.

If nevertheless the Radio does not operate properly, measure and write down AGC voltage,
make PPC monitor screenshot or write the parameters to the file, then contact to Service
Center.

Elva-1 Millimeter Wave Division Service Center

St.Petersburg, Russia
Tel: [phone]
Fax: [phone]
Email: [e-mail]

8 Specifications

System Parameters

Frequency Band: ECC&FCC E-band 71.0-76.0 & 81.0-86.0 GHz
Capacity: 1250 Mbps Full duplex Gbps Ethernet
Modulation Type: QPSK
Bandwidth: 800 MHz + 800 MHz (two bands with duplex separation)
Rx Sensitivity: -87 dBW
Output Power: 20 mW
Max Distance : 5.5 km (3.4 mile) at 5 mm/hour rain & 60 cm antennas
Network Management: SNMP enabled
Remote Parameters Monitoring: Proprietary adapter in ODU with software application

[Windows 98/2000/XP]

Data and Aux Interface

Ethernet Interface: 1000Base-SX (for multimode fiber, Standard IEEE 802.3z/D.50-1998)
Diagnostics Port (SNMP): RJ-45 [100BaseT] with optional RS-485 or RS-232

Antenna

Antenna Type: Cassegrain type antenna with radome
Antenna parameters:

Diameter, cm Gain, dB Beam angle, deg

30 43.5 0.9

45 46.5 0.6

60 50.0 0.4

Power / Environment

Power Supply AC: Input 88-132 / 176-264 Volts, 50/60 Hz [with manual voltage range
switch]

Transceiver Power Consumption: 65 W [+15W heating]
DC Power: 36 to 60 Volts DC
Power Connector: SNMP Monitor & Power connector IP-65 [optional IP-68]

PPC-1000 Rev.1.0 29 of 30 User Manual

© DOK Ltd (Mm-wave Division of ELVA-1 ltd), 2005-2006. All rights reserved.