Eltako TF-BHSB User Manual

Tap-radio® motion/brightness sensor
TF-BHSB

TF-BHSB Tap-radio® motion/brightness sensor

Wireless motion/brightness sensor pure white glossy for single mounting
84x84x27mm or mounting into the E-design switching system.
With solar cells and battery

The factory setting switches off taught-in light actuators and dimming actuators automatically
if no motion is detected for 5 minutes. Switch-on is by means of the light pushbutton.

Place a jumper in 'active' position to enable automatic motion-dependent switch-on. The
brightness threshold at which the sensor sends a Motion telegram is set by a potentiometer.

The holding plate can be screwed to a flat surface or affixed to the ceiling or wall using the
enclosed adhesive foil.

We recommend stainless-steel countersunk 2.9x25mm, DIN 7982 C, for screw connections.
Both with rawl plugs 5x25mm and with 55 mm switch boxes. An adhesice foil and a set of
2 stainless-steel countersunk screws 2,9x25mm and plugs 5x25 mm are enclosed.

The wireless sensor can be taught-in into the tap-radio
TF-TA65D, TF- TA55L, TF-TA55D, TF100L and TF100D.

(lifetime 4-5 years)

®

actuators TF61L, TF61D, TF-TA65L,

. Smart Home sensor.

private series

Recommended retail prices excluding VAT.

TF-BHSB

Wireless motion/brightness sensor

EAN 4010312318379

77,40 €/pc.