Eltako FT55H-wg Service Manual
GB
30 000 596 - 1
Wireless sensor without
battery
Friends of Hue wireless
pushbutton FT55H
Technical specifications
Temperature at the -20°C up to +50°C
installation site
Storage temperature -25°C up to +70°C
Relative humidity Annual Mean
<75%
Radio standard Zigbee wireless
Radio frequency 2,4 GHz
Connection
Friends of Hue wireless pushbutton for single
mounting 80x80x15 mm or mounting in the
55 mm switch system.
A power supply for the device is not required.
The device works through energy harvesting.
By actuating the switch, the necessary energy
is self-generated.
Included is a frame, a double rocker, an
attachment frame, the mounting base, the
wireless module, and one adhesive foil.
The wireless pushbutton can send four signals,
by pressing one of the two rockers at the top
or bottom.
(b) Adhesion:
1. Stick the adhesive pad on the mounting
plate and then place it onto the installation
site.
2.
Clip the radio module into the mounting
frame - with 0 always on top
Philips Hue Setup
1. Download Hue app (iOS or Android
2. First select Add accessory, then select
Friends of Hue switches and nally
Eltako.
3. Follow the instructions in the app to
setup the switch.
Info: To obtain the best user experience
make sure that the Hue lamp is powered
at all times. The Hue lamp can only be
operated over the Hue system when power
is supplied to the lamp. The products are
only suitable for indoor installation.
.
)
Installation site
The mounting base can be screwed onto a
at surface (a) or the adhesive pad (b) can be
used for the attachment to the wall, glass,
furniture or any other suitably surface.
Mounting
(a) Before screwing:
1. Detach the frame and mounting frame
from the mounting plate. To do this,
press the latches on the mounting
frame outwards.
2. Screw on the mounting plate at the top
and bottom.
3. Clip the frame onto the mounting frame.
Clip the radio module into the mounting
frame – with 0 always on top.
Hereby, Eltako GmbH declares that the radio
equipment type FT55H is in compliance
with Directive 2014/53/EU.
The full text of the EU declaration of
conformity is available at the following
internet address: eltako.com
Must be kept for later use!
Eltako GmbH
D-70736 Fellbach
Technical Support English:
+49 711 94350025
technical-support@eltako.de
eltako.com
33/2020 Subject to change without notice.
Loading...