1
HDMI (HDBaseT) CAT5 Extender Series
Elpro Video Labs Ed. 1 April 2014
ITEM NO.:
EL-EX-H02P
HDMI (HDBaseT) CAT5 Extender with Ethernet/RS232/IR/PoH
The HDMI HDbaseT transceiver provides full 3D (all formats), resolutions up to 4Kx2K (4 times the
1080p) with multi-channel audio, IR and RS-232 extension over a single CAT5e/6 cable. It’s fully
compliant with HDCP, EDID and CEC controls. The EL-EX-H02P also extends Ethernet to permit the on
line access to TVs, DVD Players and other network devices such as 100Base-T routers, hubs and
computers. IR channel is bi-directional, therefore in the same time you can control the destination
device from the location of the source and A/V sources from the location of the destination. HDMI,
RS232, IR and Ethernet signal can be transmitted simultaneously without affecting each other. With the
support of PoH (Power over HDBaseT) feature, the receiver is powered through the CAT5E/6 cable
eliminating the need of the power supply.
EL-EX-H02P
HDMI (HDBaseT) CAT5 Extender with Ethernet/RS232/IR/PoH
Extends HDMI, RS232 and IR signals with Ethernet over one CAT5e/6 cable.
Uncompressed high definition video up to 1080p 60Hz 16 bits.
HDMI 1.4 with 3D, 4k x 2k support, HDCP and DVI Compliant.
Max. Data Rate 10.2Gbps.
Audio supports up to LPCM 7.1 192KHz, Dolby TrueHD, DTS-HD MA
Transmission range up to 100 meters at 1080p resolution.
Bi-directional IR, support 30÷60kHz.
Bi-Directional RS232 interface – commands and data can flow in both directions via RS232, allowing
status requests and control of the destination unit.
Support two port 10/100Mbps network, allowing to connect the network TV or internet devices.
Support PoH (Power over HDBaseT), no external power required at receiver.
External power supply included for the Transmitter only.
Installation view:
2
Connection Diagram:
PLAYER Transmitter Receiver TV / PROJECTOR
┌ ─ ─ ─ ─ ┐ HDMI CABLE ┌ ─ ─ ─ ─ ─ ─ ┐ ┌ ─ ─ ─ ─ ─ ─ ┐ HDMI CABLE ┌ ─ ─ ─ ─ ─ ─ ─ ─ ─ ┐
│ HDMI │ ─ ─ ─ ─ ─ ─ ─ ─ ─ →│ HDMI │ │ HDMI│ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ →│ HDMI │
└ ─ ─ ─ ─ ┘ │ │ │ │ │ ETHERNET│
│ │ ├ ─ ─ MAX 100M ─ ─ ┤ │ │ └ ─ ─ ─ ─ ─ ─ ─ ─ ─ ┘
│ │ Link Cable │ │ ↑
┌ ─ ─ ─ ─ ┐ │ HDBaseT│ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ │ HDBaseT │ │
│ ETHERNET│ ←─ ─ ─ ─ ─ ─ ─ ─ →│ ETHERNET │ Cat.5e / Cat.6 │ ETHERNET│ ←─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ┘
└ ─ ─ ─ ─ ┘ │ │ │ │
┌ ─ ─ ─ ─ ┐ │ │ │ │ ┌ ─ ─ ─ ─ ┐
│ IR CABLE│ ←─ ─ ─ ─ ─ ─ ─ ─ →│ IR │ │ IR│ ←─ ─ ─ ─ ─ ─ ─ ─ ─ →│ IR CABLE│
└ ─ ─ ─ ─ ┘ │ │ │ │ └ ─ ─ ─ ─ ┘
┌ ─ ─ ─ ─ ┐ │ │ │ │ ┌ ─ ─ ─ ─ ┐
│ RS-232 │ ←─ ─ ─ ─ ─ ─ ─ ─ →│ RS-232 DC│ ←┐ │ RS-232│ ←─ ─ ─ ─ ─ ─ ─ ─ ─ →│ RS-232 │
└ ─ ─ ─ ─ ┘ RS-232 CABLE └ ─ ─ ─ ─ ─ ─ ┘ │ └ ─ ─ ─ ─ ─ ─ ┘ RS-232 CABLE └ ─ ─ ─ ─ ┘
┌ ─ ─ ─ ─ ─ ┐
│ DC 24V/1A│
└ ─ ─ ─ ─ ─ ┘
Cable:
Link cable recommend use high quality Cat.5e, Cat.6, Cat.6a, Cat.7 UTP / STP or FTP
cable. Poor quality cable or network connection or improper construction will cause
unstable connection, video or sound disruptions, picture noise appears.
Transmission Distance:
The maximum transmission distance is up to 100 meters at 1080p, lower resolution won’t
extend longer distance
HDBaseT Distance chart by different cable:
Cable Type Range Pixel Clock Rate Video Data Rate Supported Video
100m <=225Mhz
<=5.3Gbps
(HD Video)
Up to
1080p 60Hz 12 bpp
CAT5e / CAT6
70m
CAT6a / CAT7 100m
>225Mhz
>5.3Gbps
(Ultra HD Video)
1080p 60Hz 16 bpp,
1080p 60Hz 3D,
4K x 2K 30Hz
If connection through the wall socket, the cable length must less 5 meters between HDMI
extender and wall jack, as below drawing:
10/100Mbps network connection using general CAT5e cable and working distance up to 100M.
Transmitter
Wall Jack
Wall Jack
Receiver
MAX 100M
< 5M
< 5M
3
RJ45 Define:
LED Indication:
HDMI Port Status LED :
Color LED Function EL-EX-H02PT EL-EX-H02PR
Green Power On: Power On
Blue IR Receive On: IR Received Signal
Red IR Emitter On: IR Emitting
HDBaseT Port Status LED :
Color LED Function EL-EX-H02PT EL-EX-H02PR
Green HDBaseT Linking On: HDBaseT Linking , Flash: Low Power Mode
Blue Reserve No Function
Red HDMI On: With HDCP , Flash: Without HDCP , Off: HDMI Unlink
10/100 Ethernet Port :
Color LED Function EL-EX-H02PT EL-EX-H02PR
Green Ethernet Linking On: Linking , Flash: Data Transmission
Yellow Reserve No Function
Low-power Mode:
When there is no HDMI video signal input, TV is not connected or in stand-by, this product will enter a
low-power mode to save power consumption. Under low power mode, Ethernet, RS-232 and IR works
properly.
Caution:
1. The wiring must away from any equipment with electromagnetic wave, i.e.: mobile phone,
microwave, radio equipment, fluorescent lamp, high voltage power lines.
2. This HDBaseT port is not general Ethernet signal which also carry power, therefore do not
connect to Network to avoid damage.
3. IR transmitter and IR receiver must be placed in order to avoid mutual interference.
4
Panel view:
EL-EX-H02PT
EL-EX-H02PR
Package Includes:
Transmitter x 1 piece
Receiver x 1 piece
Power adapter DC24V 1AMP x 1 piece
IR Emitter cable x 2 pieces
IR Receiver cable x 2 pieces
Specification:
ITEM NO EL-EX-H02PT EL-EX-H02PR
HDMI Connector HDMI Type A x 1
HDMI Video Up to 1080p 60Hz 48bits, 3D, 4K x 2K
HDMI Audio Up to LPCM 7.1, 192 KHz, Dolby TrueHD, DTS-HD, MA
HDBaseT Connector RJ45 x 1
HDBaseT Distance 100M (Max)
Ethernet Connector RJ45 x 2 (with 2 LED)
Ethernet Data Rate 10 / 100Mbps
Ethernet Distance 100M (Max)
RS-232 Connector DB9 Female DB9 Male
RS-232 Baud Rate Up to 115200 bps / Full Duplex
IR Connector 3.5mm Phone Jack x 2
IR Carrier
30-60KHz / T：± 10° / R：± 55° / 5M / 2 Way
Power Supply Regulated DC 24V 1A PoH (From EL-EX-H02PT)
Power Consumption Max Total 15W, Low Power Total 5W
Temperature
Operation: 0 to 55℃, Storage: -20 TO 85℃, Humidity: up to 95%
Dimensions mm 88 x 135 x 30
Weight g 300
Rev. A
Loading...