Elo TouchSystems 2201 Quick Install Manual

Quick Install Guide

www.elotouch.com

Included Items

North America

Elo Touchsystems
301 Constitution Drive
Menlo Park, CA 94025
www.elotouch.com

Europe

Tel [phone]
Fax [phone]
[e-mail]

Asia-Pacic

Tel [phone]
Fax [phone]
www.tps.co.jp

Latin America

Tel [phone]
Fax [phone]
www.elotouch.com.ar

Elo Technical Support

Online self-help:

www.elotouch.com/go/websupport

Technical Support contacts in your region:

www.elotouch.com/go/contactsupport

Elo (logo), Elo TouchSystems, TE Connectivity, TE connectivity (logo) and TE (logo) are trademarks of the TE Connectivity Ltd. family of
companies.

DISCLAIMER:
Tyco Electronics Corporation and its Affiliates in the TE Touch Solutions business unit of the TE Connectivity Ltd. family of companies
(collectively “TE”) reserves the right to change or update, without notice, any information contained herein; to change, without notice, the
design, construction, materials, processing or specifications of any products; and to discontinue or limit production or distribution of any
products.

No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or
computer language, in any form or by any means, including, but not limited to, electronic, magnetic, optical, chemical, manual, or otherwise
without prior written permission of Tyco Electronics Corporation.

1 Webcam or MSR

2 M3 x 20mm mounting screws

1 Cable clip kit (1 clip and 1 screw)

2201 Touchmonitor Peripherals

• Webcam Kit

• MSR Kit

Revision A
P/N E177619

Copyright 2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company. All rights reserved. [04/13/2011].

US088522 - 2012-03-28T16:31:59Z

1 5

2 6

3 7

4 8

Installation

Optional: Install the cable clip
Snap the clip over the cable and
then fasten the clip to the rear
of the monitor using the screw
provided in the kit.

Route the periperals’ USB cable
through the channel in the stand
and out the back.Then replace
the cable cover.

Remove the cable routing cover
by pushing down on the snap
near the cable opening.

Tilt the monitor back to access
the cable routing cover on the
front of the stand.

Fasten the peripheral to the
touchmonitor using the two M3 x
20mm screws included in the kit.

Peel off hole covers by inserting
a small tool under the lip on the
covers.

Located the two mounting hole
covers on the back of the monitor
for the chosen location.

Choose a location to install the
peripheral.

WEBCAM OR MSR

MSR

MSR

US088522 - 2012-03-28T16:31:59Z