Elo TouchSystems 15A2 Quick Installation Manual For Modem Card

Revision A
P/N E854457

821107901401

Installing additional Modem Card for the 15A2

2008 Tyco Electronics.

North America

Elo TouchSystem
301 Constitution Drive,
Menlo Park, CA 94025
www.elotouch.com

Europe

Tel [phone]
Fax [phone]
[e-mail]

Asia-Pacific

Tel [phone]
Fax [phone]
www.tps.co.jp

Latin America

Tel [phone]
Fax [phone]
www.elotouch.com.ar

Elo Technical Support

:

www.elotouch.com/go/websupport

www.elotouch.com/go/contactsupport

Online self-help

Technical Support contacts in your region:

For current Elo news, product updates and announcements, register to receive our TouchMonitor newsletter
at www.elotouch.com/go/news

Reconnect the power adapter, connect a keyboard and power on the
touchcomputer. While the TE logo is displayed, press the “Del” key to
enter the BIOS setup menu. Follow the below screen shots to configure
the modem card setting.

Insert the software CD into the
DVD drive (or USB DVD drive) and
follow the instructions to complete
the modem card software installation.

11

When modem setup is complete, press “F10” and then the “Enter”
key to save settings and restart the touchcomputer.

10

1

2

3

4

5

DVD/CD

4

Adjust the cable clip, then unscrew
the nut and cable clip.

Remove the four screws connecting the
stand to the chassis. Once these screws
are removed, the stand will come off.
Then remove the four screws on the
chassis.

Align the pins on the modem card with
the connector on the PC board and
press together until it locks into place.
Connect the RJ11 cable to the connector
on the main board as shown.

1

2

5

8

7

Replace the cable clip and nut. Use
the additional provided nut to further
secure the modem. Ensure that the
cable clip neatly holds the internal
cable as shown.

6

3

Take the provided RJ11 cable and
connect it to the modem card.

Turn off power to the touchcomputer
and unplug the power adapter from
the unit.

B

A

Reinstall the four screws to close
the chassis and then reinstall the
stand using the screws removed
in Step 3.

9

Replace the back cover insert.

Carefully place the touchcomputer
facedown on a soft, flat surface.
Turn touchcomputer upside down
and take off the back cover insert.

●

Note: Always handle the component by its edges.

●

Installer must be electrically grounded while performing installation steps.