USER MANUAL
Elo Touch Solutions
Touch All in one computer
i-series 2.0
UM600106
Rev A, page
2of32
User Manual – i-series 2.0
Copyright © 2017 Elo Touch Solutions, Inc. All Rights Reserved.
No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer
language, in any form or by any means, including, but not limited to, electronic, magnetic, optical, chemical, manual, or otherwise without prior written
permission of Elo Touch Solutions, Inc.
Disclaimer
The information in this document is subject to change without notice. Elo Touch Solutions, Inc. and its Affiliates (collectively “Elo”) makes no representations or
warranties with respect to the contents herein, and specifically disclaims any implied warranties of merchantability or fitness for a particular purpose. Elo
reserves the right to
Revise this publication and to make changes from time to time in the content hereof without obligation of Elo to notify any person of such revisions or
changes.
Trademark Acknowledgments
Elo, Elo (logo),Elo Touch, Elo Touch Solutions, are trademarks of Elo and its Affiliates.
UM600106
Rev A, page
3of32
User Manual – i-series 2.0
Table of Contents
Section 1: Introduction ......................................................................................................................................................................................................................4
Section 2: Unpacking and Operation .................................................................................................................................................................................................5
Section 3: Technical Support and Maintenance...............................................................................................................................................................................20
Section 4: Safety.............................................................................................................................................................................................................................23
Section 5: Regulatory Information ......................................................................................................................................................................錯誤! 尚未定義書籤。
Section 6: Warranty Information ...................................................................................................................................................................................................... 31
UM600106
Rev A, page
4of32
User Manual – i-series 2.0
Section 1: Introduction
Product Description
Your new i-Series 2.0 Interactive Signage system combines the reliable Elo Touch Solutions performance
with the latest developments in touchscreen technology and display design. This combination of features
creates a natural flow of information between a user and the i-Series 2.0 system.
This i-Series 2.0 system incorporates an active matrix thin-film-transistor and LCD panel to provide superior
display performance. Features that enhance this systems performance are a Projected Capacitive
(PCAP) touchscreen, Plug & Play compatibility, Micro-HDMI Out, LAN/Wifi, built-in speakers and
headphone output capability (via a USB dongle). A general purpose input/output header is available
and Bluetooth 4.1 is supported. 3G/4G LTE (Micro SIM card holder) support is available as an optional
peripheral.
Precautions
Follow all warnings, precautions and maintenance as recommended in this user manual to maximize the
life of your unit and prevent risks to user safety. See Section 4 for more information on safety.
This manual contains information that is important for the proper setup of the i-series 2.0 system. Before
setting up and powering on your i-series 2.0 system, read through this manual, especially Unpacking and
Operation, Safety, and Technical Support and Maintenance chapters.
UM600106
Rev A, page
5of32
User Manual – i-series 2.0
Section 2: Unpacking and Operation
Box Contents
Verify that the box contains:
•
I-series 2.0 system
•
Quick Install Guide
•
Power brick
•
North American Power Cable
•
Europe Power Cable
•
Two (2) cable strain reliefs
•
Two (2) screws
The connectors are accessed by removing the cable security covers from the rear of the i-Series 2.0 system.
UM600106
Rev A, page
6of32
User Manual – i-series 2.0
Elo i-series 2.0 Layout
UM600106
Rev A, page
7of32
User Manual – i-series 2.0
For units with Power over Ethernet Support
UM600106
Rev. A, page
8of32
User Manual – i-series 2.0
i-series 2.0 EloView Engine
The Eloview engine can be mounted to various Elo monitors using the VESA pattern or with optional monitor brackets.
UM600106
Rev. A, page
9of32
User Manual – i-series 2.0
Power
Press the power button to turn the Elo i-series 2.0 on. Press and hold power button when the system is on to bring up the Shut Down option popup.
In the event that the system freezes and does not respond, press and hold the power button until the system turns off. If the system does not turn
off via the power button, the system will need to be powered down by unplugging the power cord from the wall.
The Elo I-series 2.0 power button is equipped with an LED that indicates the power status of the system, as follows:
Register power status Led status
OFF (disconnected from wall) Off
OFF (connected to wall) Red (Solid)
SLEEP White (Blinking)
ON White (Solid)
The system consumes low power when in SLEEP and OFF modes. For detailed power consumption specifications, refer to technical specifications
available on the Elo website www.elotouch.com.
To bring the system out of sleep/standby mode, press the power button once. If the system is in sleep mode, touching the screen will wake up the
system
If long periods of non-use are planned, turn off and unplug the Elo I-series 2.0 to save power.
The maximum voltage, frequency and current for the systems, are provided in the power ratings table below:
Product Operating Voltage Range Operating Frequency Range Operating Current Range
10.1in 100 - 240Vac 50 – 60 Hz
15.6in 100 - 240Vac 50 – 60 Hz
21.5in 100 - 240Vac 50 – 60 Hz
Eloview Engine 100 - 240Vac 50 – 60 Hz
UM600106
Rev. A, page
10of32
User Manual – i-series 2.0
Operating System
System comes with Android 7.0.1 pre-loaded.
Touch Technology
The i-series 2.0 uses Projected Capacitance touch screens, 10 simultaneous touches can be reported at one time.
Gesturing Images
For multi-touch monitors, the following gestures are possible:
Dual Touch Gestures and their Functions:
Swipe – The action of moving a finger across the screen.
The ability to swipe through from one picture to another or drag an icon
Pinch-Zoom – Zoom into a picture
- Place two fingers on the screen and move them closer together to zoom in. Move your fingers away from each other to zoom out.
Before zoom After zoom
Loading...