Elo Touch 17A2 Quick Installation Guide for Magnetic Stripe Reader

Note: For ESY17A2 and ESY15A2 touchcomputers, the software for the peripheral
is already installed on the touchcomputer. For the ET1729L touchmonitor, refer to
the following:

Make sure a USB cable is connected to the
USB connector on unit.

Connect the other end of the USB cable to
a USB port in your computer.

821107900502

Installing the Magnetic Stripe Reader (MSR)

for 1729/17A2/15A2

Caution:
Before attaching the MSR to your monitor, make sure that power to the monitor and computer is off.

Revision B
P/N E884104

2008 Tyco Electronics.

North America

Elo TouchSystem
301 Constitution Drive,
Menlo Park, CA 94025
www.elotouch.com

Elo Technical Support

Online self-help

www.elotouch.com/go/websupport

Technical Support contacts in your region:

www.elotouch.com/go/contactsupport

:

Europe

Tel [phone]
Fax [phone]
[e-mail]

Asia-Pacific

Tel [phone]
Fax [phone]
www.tps.co.jp

Latin America

Tel [phone]
Fax [phone]
www.elotouch.com.ar

1

Turn off power to the unit and
computer.

5

Secure the Magnetic Stripe Reader
(MSR) to the monitor using two screws
from the Magnetic Stripe Reader (MSR)
Kit.

2

3

4

Turn unit upside down and take off
the back cover insert.

Unsecure the Magnetic Stripe Reader
(MSR) door from the unit’s right
side.

Place the Magnetic Stripe Reader (MSR)
onto the rear of the unit, along the
unit’s side.

6

Insert the connector of the cable
accompanying the MSR into the
mating connector on the accessory
hub in the rear of the unit.

7

Replace the back cover insert.

8

Place the unit upright then turn on.