Elo Touch 17A2 Quick Installation Guide for Customer Display

Note: For ESY17A2 and ESY15A2 touchcomputers, the software for the peripheral
is already installed on the touchcomputer. For the ET1729L touchmonitor, refer to
the following:

Make sure a USB cable is connected to
the USB connector on unit.

Connect the other end of the USB cable
to a USB port in your computer.

821107900602

Installing the Customer Display for 1729/17A2/15A2

Caution:
Before attaching the Customer Display to your monitor, make sure that power to the monitor and computer is off.

Revision B
P/N E605258

North America

2008 Tyco Electronics.

Elo TouchSystem
301 Constitution Drive,
Menlo Park, CA 94025
www.elotouch.com

Elo Technical Support

Online self-help

www.elotouch.com/go/websupport

Technical Support contacts in your region:

www.elotouch.com/go/contactsupport

:

Europe

Tel [phone]
Fax [phone]
[e-mail]

Asia-Pacific

Tel [phone]
Fax [phone]
www.tps.co.jp

Latin America

Tel [phone]
Fax [phone]
www.elotouch.com.ar

1

Turn off power to the unit and computer.

5

Secure the Customer Display to the
unit using two screws from the
Customer Display Kit.

2

3

4

Turn unit upside down and take off the
back cover insert.

Unsecure the Customer Display door
from the unit’s top side.

6

Insert the connector of the cable
accompanying the Customer
Display into the mating connector
on the accessory hub in the rear
of the unit.

7

Replace the back cover insert.

8

Place the Customer Display onto the rear
of the unit, along the unit’s top side.

Place the unit upright then turn on.