Elo Touch 17A2 Quick Installation Guide for Memory 512MB/1GB RAM

821107901102

Installing additional RAM for the 17A2/15A2

Revision B
P/N E065273

North America

Elo TouchSystem

2008 Tyco Electronics.

301 Constitution Drive,
Menlo Park, CA 94025
www.elotouch.com

Elo Technical Support

Online self-help

www.elotouch.com/go/websupport

Technical Support contacts in your region:

www.elotouch.com/go/contactsupport

:

For current Elo news, product updates and announcements, register to receive our TouchMonitor newsletter
at www.elotouch.com/go/news

Europe

Tel [phone]
Fax [phone]
[e-mail]

Asia-Pacific

Tel [phone]
Fax [phone]
www.tps.co.jp

Latin America

Tel [phone]
Fax [phone]
www.elotouch.com.ar

●

Note: Always handle the component by its edges.

●

Installer must be electrically grounded while performing installation steps.

Note on adding/removing memory modules:

Be careful, as improper installation or removal of a memory module can
cause harmful damage to your touchcomputer. Only install memory modules
that are compatible with your touchcomputer. The module packaged with this
accessory kit meets the requirements for this touchcomputer.
Be careful when handling a memory module, as ESD can damage the module.

1

Turn off power to the touchcomputer
and unplug the power adapter from

the unit.

2

Turn touchcomputer upside down and
take off the back cover insert

5

6

Align the pins of the memory module
with the connector at an angle and
push it in until the pins are in place.
Then push the memory module down
until it clicks. If it clicks, then it means
the module was installed successfully.

Reinstall the four screws to close
the chassis and then reinstall the
stand using the screws removed
in Step 3.

3

4

Remove the four screws connecting the
stand to the chassis. Once these screws
are removed, the stand will come off.
Then remove the four screws on the
chassis.

To remove an existing memory module,
pull the two metal latches away from the
modules until the module is released.
The module should tilt up and then can
be safely removed.

7

Replace the back cover insert.

8

Reconnect the power adapter and
power on the touchcomputer.
You may use the operating system
to verify that the additional memory
was installed properly.