Elo Touch 17A2 Quick Installation Guide for Speaker Bar

Note: For ESY17A2 and ESY15A2 touchcomputers, the software for the peripheral is
already installed on the touchcomputer. For the ET1729L touchmonitor, refer to the following:

11

Make sure a USB cable is connected to the USB
connector on unit.

12

Connect the other end of the USB cable to a USB
port in your computer.

Note: Driver installation necessary for barcode scanner only.

1

4

7 8

10

11

2

3

Installing the Speaker Bar/Scanner for 1729/17A2/15A2

Caution:

5

6

9

2008 Tyco Electronics.

North America

Elo TouchSystem
301 Constitution Drive,
Menlo Park, CA 94025
www.elotouch.com

12

821107900702

Before attaching the Speaker Bar to your monitor, make sure that power to the monitor and computer is off.

Revision B
P/N E286199

Elo Technical Support

Online self-help

www.elotouch.com/go/websupport

Technical Support contacts in your region:

www.elotouch.com/go/contactsupport

:

Europe

Tel [phone]
Fax [phone]
[e-mail]

Asia-Pacific

Tel [phone]
Fax [phone]
www.tps.co.jp

Latin America

Tel [phone]
Fax [phone]
www.elotouch.com.ar

1

Turn off power to the unit and
computer.

6

Secure the left and right accessory
covers to the unit using two screws
from the Speaker Bar/Scanner kit.
Note: If installing the Speaker Bar/
Scanner on an ESY17A2 or ESY15A2
touchcomputer, skip steps 7-9

2

3

4

Turn unit upside down and take
off the cable cover insert.

Unsecure the left and right accessory
covers from the unit’s bottom side.

Place the Speaker Bar/Scanner onto
the rear of the unit, along the unit’s
bottom side. Secure the Speaker Bar
to the unit using two screws from the
Speaker Bar/Scanner kit.

7

8

9

Take off the back cover insert.

Insert the connector of the cable
labeled barcode scanner into the
mating connector in the accessory
hub on the top of the unit.
Note: If installing only Speaker Bar
without scanner, skip this step.

Replace the back cover insert and
cable cover insert.

5

Insert the connector of the cable
(both of right and left) accompanying
the scanner into the mating connector
on the accessory hub in the side of
the unit.
Note: If installing only Speaker Bar
without scanner, only connector on
the right will be present.

10

Place the unit upright then turn on.