Elo E135387 Quick Start Guide

Included items:

1x X-Series Touchcomputer
1x US Power Cable
1x European Power Cable
1x Power Brick

Elo Touch Solutions Technical Support

Online self-help: www.elotouch.com/go/websupport

Technical Support contacts in your region:

www.elotouch.com/go/contactsupport

www.elotouch.com

Quick Installation Guide

X-Series

All-in-One TouchComputer

Revision A

P/N E001016

North America

Elo Touch Solutions
1033 McCarthy Boulevard
Milpitas, CA 95035

800-ELO-TOUCH
Tel [phone]
Fax [phone]
[e-mail]

The information in this document is subject to change without notice. Elo Touch Solutions, Inc. and its Afliates (collectively “Elo”) makes
no representations or warranties with respect to the contents herein, and specically disclaims any implied warranties of merchantability or
tness for a particular purpose. Elo reserves the right to revise this publication and to make changes from time to time in the content hereof
without obligation of Elo to notify any person of such revisions or changes.

No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or
computer language, in any form or by any means, including, but not limited to, electronic, magnetic, optical, chemical, manual, or otherwise

without prior written permission of Elo Touch Solutions, Inc.

Elo (logo) and Elo Touch Solutions are trademarks of Elo and its Afliates.

© 2014 Elo Touch Solutions, Inc. All rights reserved.

Europe

Tel [phone]
Fax [phone]

[e-mail]

Asia-Pacic

Tel [phone]
Fax [phone]

www.elotouch.com.cn

Latin America

Tel [phone]
Fax [phone]
www.elotouch.com

Go to www.elotouch.com/support to download user manual.

The stand supports both
upright and lowered
orientations. The stand is
set to the lowered postion
from the factory. Change
the orientation to upright by
removing the green colored
screws from the bottom of
the stand and install them in
the location marked by the
arrows

Serial RS-0232

The power button is located at
the bottom as shown.

+24V PUSB

(X3/X5/X7 models only)

Tilt the display back to
access the I/O connections
and remove the cable cover.

Connect the power cable to
the DC power jack marked
by the arrow. Then route the
cable through the cable clips
and through the bottom of the
stand.

Ethernet and

RS-232 and

USB X2

USB X2

Mic / headphone out

USB X2

VGA

DC Power

Input