ElmoTech TRXS-860, TRXS-860-2 User Manual
Wrist Tag
TRXS-860
USER MANUAL
October 2011
ElmoTech Ltd.
TRXS-860 -
User Manual
1
Table of Contents
1. Foreword ....................................................................................2
2. Installing the Wrist Tag. .............................................................3
3. General Rules for the Client ......................................................6
4. Maintenance Instructions ...........................................................7
4.1. Cleaning the Wrist Tag ..............................................................7
4.2. Wrist Tag Straps Replacement ...................................................8
5. FCC Notices .............................................................................10
ElmoTech Ltd.
TRXS-860 -
User Manual
2
1.
Foreword
The Wrist Tag (TXRS-860) is a transmitter, used in home
arrest systems.
The Wrist Tag (TXRS-860 / TRXS-860-2) is transmitting on an
American FCC tested and approved frequency; whereas the
European version (TXRS-860-2) is transmitting on a European
tested and approved frequency. From a user interface and
function point of view the two models are identical; therefore this
user manual serves both versions.
ElmoTech Ltd.
TRXS-860 -
User Manual
3
2.
Installing the Wrist Tag.
Hold the transmitter in your hand with the metal pins (along the
strap) pointing forward.
Hold the Electronic Key in your other hand, with the black button
pointing toward the open or free end of the strap.
Press the Electronic Key over the metal pins with the two touch
points on the Electronic Key matching the metal pins on the
Transmitter strap. Hold the
Electronic key in this position
while you do the next step.
Hold the Electronic key in this
position while you do the next
step.
Press the red button on the
Electronic Key down for one
second; the red light turns steadily on for two (2) seconds.
If the transmitter successfully receives the reset command, the red
light, on the Electronic Key, will flash for two (2) seconds.
Note that if the Tag has failed to receive the startup command the
red light will turn off after the initial two (2) seconds ON.
If the Electronic Key battery is low the red light will immediately
flash for two (2) seconds, once the red button is pressed. (No
command is sent to the transmitter).
Loading...