Page 1
RSU-200
Remote Control Extension Unit for PTC-200C / PTC-100S / PTC-110R
INSTRUCTION MANUAL
PART NAMES
Infrared Sensor
LED
DC IN
RS-232C IN Terminal
Composite Video Out
(RCA pin jack)
Camera IN
Page 2
DIP SWITCH SETTING
Be sure to turn ON No.1 of the DIP Switch(4) on the bottom of the Camera
before turning ON the power supply to the Camera.
CONNECTION
OPERATION
The infrared emitting window of the wireless remote controller is requested to point
at the Infared Sensor of RSU-200 whenever the controller is in use.
When the unit recieves the IR signal, the LED of RSU-200 lights up.
Note:
* It is not possible to control the "POWER" button of the wireless remote controller.
*It is not recommended to use ID number setting by wireless remote controller,
when external control (RS-485) is activated.
use of the RSU-200
AC Adaptrer
PC
Monitor
RSU-200
(supplied)
Switch
( )
( )
DIP Switch(4) of the Camera
BNC Video Cable
RCA Video Cable
(supplied)
BNC/RCA
Conversion
Plug
PTC-200C
PTC-100/PTC-110R
Page 3
INTERNAL SWITCH
When the unit is used for a long distance, select "LONG" ON the internal switch of RSU-200.
It is recommended to use the unit within 500m(1640 ft) from PTC Cameras when the 5C-2V
cable is used.
SPECIFICATIONS
Power source
12V DC
Power consumption
2.5W
Operating temperature
32 degF - 104 degF
Operating humidity
30% - 85%
Outside dimensions
98mm(H)x96mm(D)x36mm(H)
3.8in.(H)x3.8in.(D)x1.4in.(H)
Weight
300g (0.66 lbs)
Page 4
RS-232C SPECIFICATIONS
Pin assignment
Pin No.
Code
1
DTR
2
DSR
3
TXD
4
GND
5
RXD
6
GND
7NC8NCTransmission specifications
* Full duplex start-stop sync. mode.
* Start bit
: 1 bit
* Data bit
: 8 bits
*Stop bit
: 1 bit
* Parity bit
: None
* X parameter
: None
* Baud rate
: 9600 bps
* Electric interface
: RS-232C (Mini DIN 8P connector)
* Flow control
: None
* Cable specification
: Dedicated cable
RSU-200
PC
RSU-200
PC
(D-sub 9P)
(Mini DIN 8P)
1.DTR
1.CD
1.DTR
1.DTR
2.DSR
2.RXD
2.DSR
2.DSR
3.TXD
3.TXD
3.TXD
3.TXD
4.GND
4.DTR
4.GND
4.GND
5.RXD
5.GND
5.RXD
5.RXD
6.GND
6.DSR
6.GND
6.GND
7.NC
7.RTS
7.NC
7.OPEN
8.NC
8.CTS
8.NC
8.OPEN
9.RI
SUPPLIED ACCESSORIES
Instruction manual
Video cable
AC adaptor
-
Name
Data Terminal Ready
Data Set Ready
Transmitted Data
Ground
Received Data
Ground
-
RS-232C Connector
Loading...