Elmdene G1380xN-y-s, G1380xN-2-s, G1380xN-s, G1380xN-4-s, G1380xN-8-s Series Manual
...
1
Technical Support: +44(0)23 9269 6638 (option 3) PAK200500_03C Dec 2016 ©2016 ELMDENE INTERNATIONAL LTD
13.8V dc Switch Mode Power Supply with Optional Fused Outputs
G1380xN-y-s
F
EATURES
High efficiency cost effective power supply ideal for use in Intruder, Access Control and General
Security applications. Featuring a regulated 13.8Vdc output supplying continuous full rated current to
load and up to an additional 0.5A for charging a standby battery. The universal mains input voltage
enables the power supply to be used across a wide geographical area. The highly efficient switch
mode design ensures low operating costs, generates less heat and with a small physical size increases
the room available for additional PCBs or cables. The modular construction simplifies maintenance. An
optional integrated output module allows multiple circuits to be individually fused*.
• Continuous full rated current to load
• Additional 0.5A to charge standby battery
• Universal mains input voltage 90-264Vac
• High efficiency electronics for reduced running costs and lower operating temperatures
• Installer safe design with all high voltage electronics fully shrouded
• Modular construction for ease of maintenance and installation
• Full electronic short circuit and overload protection on load output under mains operation
• Mains transient protection circuit
• Lid opening tamper detection
• Green Mains present LED
• Red Fault LED*
• Individually Fused Outputs*
* Dependent upon model.
C
OMPLIANCE
This power supply unit meets the essential requirements of the following European Directives:
Low Voltage 2014/35/EU EMC 2014/30/EU WEEE 2012/19/EU RoHs2 2011/65/EC
S
PECIFICATION (INPUT
)
Voltage (rated) 100-240Vac
Voltage (operating) 90-264Vac
Frequency 50-60Hz
Max current See Model Specification Table overleaf
Mains Input Fuse See Model Specification Table overleaf
Max standby Power 0.5W (No load and No battery connected)
Elmdene International Ltd
Tel: +44(0)23 9269 6638
3 Keel Close, Interchange Park, Fax: +44(0)23 9266 0483
Portsmouth, Hampshire, PO3 5QD, UK
Web: www.elmdene.co.uk
2
Technical Support: +44(0)23 9269 6638 (option 3) PAK200500_03C Dec 2016 ©2016 ELMDENE INTERNATIONAL LTD
S
PECIFICATION (OUTPUT
)
Voltage 13.4 – 14.2Vdc (13.8Vdc nominal) on mains power
10.0 – 12.3Vdc on battery standby
Max load current See Model Specification Table overleaf
Ripple 150 mV pk-pk max
Load output Fuse See Model Specification Table overleaf
Overload Electronic shutdown until overload or short circuit removed
(under mains power only)
S
TANDBY BATTERY
Battery Type 12V Valve Regulated Lead Acid
Battery Capacity See below under enclosure size.
L
OCAL INDICATORS
MAINS LED (Green) Mains present
FAULT LED (Red)*
Fault present: Output fuse fail
*
Not 4A or 5A
S
IGNALLING OUTPUTS
Lid Tamper N/O volt free contact (See Table for rating).
Note: Contact open when lid opened by normal means
(TAMPER ACTIVE condition).
F
USED OUTPUTS (OPTIONAL
)
Model G1380xN-s G1380xN-2-s G1380xN-4-s G1380xN-8-s
No. of fused outputs
1 2 4 8
Fuse Value See table
overleaf
2 x (max load
current / 2)
4 x (max load
current / 4)
8 x (max load
current / 8)
M
ECHANICAL
Model G1380xN-y-A G1380xN-y-B G1380xN-y-C G1380xN-y-F
Enclosure Dimensions
w x h x d (mm) [external]
230 x 200 x 80 355 x 330 x 80 330 x 275 x 80 380 x 230 x 75
Battery Capacity 1 x NP7 (8Ah) 1 x NP17 (18Ah) 1 x NP17 (18Ah) 1 x NP7 (8Ah)
Weight (kg)
(Excluding Battery)
1, 1.5, 2, 3A 1, 2, 3A 4, 5A 1, 2, 3A 4, 5A 1, 2, 3A
2.0 3.9 4.3 3.3 3.7 3.5
E
NVIRONMENTAL
Temperature – Operating -10 to +40°C (operating) 75% RH non-condensing
Temperature - Storage -20 to +80°C (storage)
Loading...