Elliott 99062 Series, 99062-110-7P, 99062-220-7P Operating And Maintenance Instructions Manual

99062 Series Electric Rolling Motor

For 1/4” – 5/8” (6.35mm – 15.88mm) Tube O.D.

Tube & Pipe Cleaners Tube Testers Tube Plugs Tube Removal Tube Installation

Operating and Maintenance Instructions

WARNING: Read these instructions before using this tool.

www.elliott-tool.com

Table of Contents

Introduction .......................................................................................................... 4

Safety Instructions ................................................................................................ 5

Setup .................................................................................................................... 7

Troubleshooting Electric Rolling Motors............................................................... 9

Care & Maintenance ........................................................................................... 10

Brush Replacement ............................................................................................ 11

99062 Series Parts Diagram ............................................................................... 12

99062 Series Parts List ...................................................................................... 13

Technical Information ......................................................................................... 14

Warranty ............................................................................................................. 15

99062 Series 3

Introduction

Thank you for purchasing this Elliott product. More than 100 years of experience have been employed in
the design and manufacture of this tool, representing the highest standard of quality, value and durability.

Elliott tools have proven themselves in thousands of hours of trouble free eld operation.

If this is your rst Elliott purchase, welcome to our company; our products are our ambassadors. If this is
a repeat purchase, you can rest assured that the same value you have received in the past will continue
with all of your purchases, now and in the future.

The Elliott 99062 Series Electric Rolling Motor is to be used with the Elliott Model ELC110220 Electronic
Torque Controller to expand tubes in the following types of equipment:

Heat Exchangers

Condensers

Chillers

Evaporators

Air Conditioners

If you have any questions regarding this product, manual or operating instructions,
please call Elliott at [phone] toll free (USA only) or [phone], or fax us at [phone]
for immediate service.

4 99062 Series

Safety Instructions

1. Read all safety and operating instructions contained in this manual prior to use of the tool. Failure

to follow all instructions listed below may result in electrical shock, re and/or serious injury.

2. Do not operate this tool while under the inuence of drugs or alcohol.

3. Do not operate this tool in an explosive atmosphere, such as in the presence of ammable
liquids, gases or dust.

4. Check the motor, cable and plug prior to every use of the tool. Repair or replace any defective
parts prior to use of the tool.

5. Do not use motor in wet conditions.

6. Use only extension cords and plugs approved for outdoor use when working outdoors.

7. Use appropriate safety equipment (i.e. safety glasses, ear plugs, dust masks, etc.) when using
this tool.

8. Ensure that long hair or loose tting clothes are secure prior to use of the tool.

9. Do not use motor without the additional handle.

10. Never apply the motor to an unsecured work piece.

11. Power cable should be located to the rear of the motor during operation, away from the rotating
spindle.

12. Always hold the motor with both hands and maintain a safe stance during use.

13. Stay clear of any objects that may interfere with the operator’s ability to maintain control of the
motor as it reaches maximum torque.

14. Always disconnect the motor from the power source prior to performing any maintenance or
repairs.

Protection

To avoid damage to the tool and/or possible injury to the operator:

Do not continue to run the motor after the motor has reached its maximum torque.

Do not operate the motor beyond the maximum amperage rating shown on the name plate.

Use only original replacement parts from the motor manufacturer.

99062 Series 5