Elkay VRCTL Installation Manual

Installation Instructions

Cane Touch Apron

TOOLS REQUIRED:

• Phillips Head Screwdriver

• Pinned Torx Head Driver

• Power Drill with 1/8” Drill Bit

• Hammer and Center Punch

INSTALLATION PROCEDURE:

1) Using template provided mark hole locations on front of left and
right side panels.

TOP - Align with corner between side panel and dispenser

panel. (See Fig. 1, Item A)

OUTSIDE EDGE - Align with outside edge of side panels.

(See Fig. 1, Item B)

2) Drill 1/8” diameter holes at marked locations. (Center punch
hole locations before drilling) When drilling the right hand hole,
on refrigeration units, be certain to drill straight.
CAUTION: Keep the drill bit away from the refrigeration
condenser. If the drill damages or punctures the condenser
refrigeration tubing severe and expensive damage to the
refrigeration system will result.

TOP

Right-

Side

1/8” DIA. HOLE

BOTTOM

OUTSIDE EDGE

TOP
Left-

Side

3) Loosen and remove screws from underside of cooler/fountain
dispenser panels.

4) Install cane touch apron to underside of cooler/fountain
dispenser panels.

5) Reuse fasteners removed in step 3 above.

6) Attach lower edges of apron to cooler side panels with screws
provided. (Using two holes drilled in step 2 above)

STAINLESS STEEL CANE TOUCH APRON PART NO. = 28694C

TEMPLATE (SEE INSTALLATION NO. 1)

OUTSIDE EDGE

1/8” DIA. HOLE

98233C (03/06)

BOTTOM

UNIT (W/O REFRIG.)

A

B

CANE TOUCH

APRON

SEE INSTALLATION NO. 6

1/8” DIA. HOLE

(SEE INSTALL NO. 2)

Fig. 1

REPAIR SERVICE INFORMATION TOLL FREE NUMBER 1.800.260.6640

ELKAY MANUFACTURING COMPANY • 2222 CAMDEN COURT • OAK BROOK, IL 60523 • 630.574.8484

98233C (03/06)

FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.323.0620