MPW200
Mounting Plate Instructions
Model MPW200
Installer
To assure you install this model easily and correctly,
PLEASE READ THESE SIMPLE INSTRUCTIONS BEFORE STARTING THE
INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE WITH
PLUMBING, ELECTRICAL AND OTHER APPLICABLE CODES. After installation,
keep these instructions for future reference.
IMPORTANT
ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON
Parts List
Refer to the illustration to make sure you receive all mounting plate parts. If any parts are missing contact
your local distributor or call 1.800.260.6640.
ITEM NO.
1
2
3
4
QTY.
1
32
32
8
PAR T NO . DESCRIPTION
28793C
70020C
75541C
75708C
Mounting Plate
Hex Nut 5/16-18
Flat Washer .339/.359ID
Threaded Rod 5/16-18 x 6 In.
1
2
PAGE 1 98373C (12/07)
3
4
MPW200
This Mounting Plate System is designed for use with the following models:
HRF Series, Barrier Free SoftSides®, OVL II™, and SWIRLFLO® Series.
MTG. HOLES FOR
THREADED RODS
HRF Series,
Barrier Free SoftSides
Fig. 1
®
MTG. HOLES FOR
THREADED RODS
MTG. HOLES FOR
THREADED RODS
OVL II™ Series
Fig. 2
SwirlFlo® Series
Fig. 3
PAGE 298373C (12/07)
MPW200
HRF Series/Barrier Free SoftSides
®
When mounting plate directly to wall studs please refer to the
diagrams shown below. For electrical, waste, and water supply locations please
refer to the Installation/Owners manual.
3/8" MTG. HARDWARE
(SUPPLIED BY OTHERS)
MTG. PLATE
MTG. HARDWARE
(SUPPLIED)
FINISHED WALL
FOUNTAIN
MTG. HOLES
32"
813mm
FOUNTAIN
16"
406mm
MTG. HOLES
5/8"
16mm
26 9/16"
675mm
12 3/4"
324mm
27"
*
686mm
FINI SHED WALL
FINISHED FLOOR
* ADA REQUIREMENT
NOTE - AFTER INSTALLATION, THREADED RODS MAY NEED TO BE TRIMMED.
PAGE 3 98373C (12/07)