Elkay MFWSF100, MFWSF120 Installation Manual

MFWSF100 / MFWSF120 MOUNTING FRAME INSTRUCTIONS

MFWSF120

3"
76mm

5/16" SCREWS OR BOLTS

(10 REQ'D - NOT FURNISHED)

FRAME

INSTALL (2) SCREWS

(P/N 111008343890) IN FRAME

BEFORE INSTALLING IN OPENING

18 3/4"
476mm

31 3/4"
806mm

25"
635mm

1. Cut a square rectangular wall opening 18 3/4” (476mm) W x 31 3/4” (806mm) H and 25” (635mm) above

the oor line. These dimensions are required to obtain proper rim and bubbler heights for compliance with ANSI
standard A117.1.

2. Reinforce the wall opening on all sides so that it will adequately support the water fountain. This reinforcement
must support up to 150 lbs static load and provide a means for securing the frame assembly in place.

3. Install plumbing rough-ins.

4. Remove frame assembly and related hardware from packaging. Install the frame squarely in wall opening with

frame upright edges ush with the nished wall face. Secure the frame to the wall using (10) 5/16” bolts
or screws (not provided). Tighten securely.
NOTE: Be sure that frame is squared in location. Do not use less than required screw quantity and size.

FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.323.0620

1000001943 (Rev. A - 2/15)