Elkay MFWS220 Installation Manual

MFWS200 / MFWS220 MOUNTING FRAME INSTRUCTIONS

MFWS220

OPTIONAL BRACKET FOR ACCESS PANEL

5/16" SCREWS OR BOLTS

(20 REQ'D - NOT FURNISHED)

5/16" HEX NUT

(4 REQ'D - PROVIDED)

P/N 111577343890

BOLT FRAMES TOGETHER

WITH 5/16" X 3/4" (19mm) BOLTS

(4 REQ'D - PROVIDED)

P/N 111577243890

INSTALL (2) SCREWS

(P/N 111008343890) IN FRAME

BEFORE INSTALLING IN OPENING

OPTIONAL BRACKET FOR ACCESS PANEL

FRAME

WOOD OR STEEL FRAME SHOWN (NOT PROVIDED)

37 1/2" 952mm

OPTIONAL FOR ACCESS PANEL

3" 76mm

8 5/8"

219mm OPTIONAL FOR ACCESS PANEL

FLOOR LINE

10 1/4" 260mm

31 1/2" 800mm

25" 635mm

1. Cut a square rectangular wall opening 37 1/2” (953mm) W x 31 1/2” (800mm) H and 25” (635mm) above

the oor line. These dimensions are required to obtain proper rim and bubbler heights for compliance with ANSI standard A117.1.

2. Reinforce the wall opening on all sides so that it will adequately support the water fountain. This reinforcement must support up to 150 lbs static load and provide a means for securing the frame assembly in place.

3. Install plumbing rough-ins.

4. Remove frame assembly and related hardware from packaging. Attach the two frames together thru the

upright supports with (4) 5/16” x 3/4” (19mm) long bolts and nuts (provided). Tighten securely.

5. Install the frame assembly squarely in wall opening with frame upright support edges ush with the nished wall face. Secure the frame to the wall thru holes with (12) 5/16” bolts or screws (not provided). Tighten securely. NOTE: Be sure that frame is squared in location. Do not use less than required screw quantity and size.

FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.323.0620

0000000755 (Rev. B - 10/13)