Elkay LRAD252265PDC Installation Manual

Installation Instructions for Wall
Mount and Deck Mount Faucets

ELKAY . 2222 CAMDEN COURT . OAK BROOK, IL. 60523 USA

Page 1

A55483 (Rev. B - 9/10)

WALL MOUNT ASSEMBLY

General Instructions

 Turn off the water supply at the main source.

Wall/Backsplash

 Hand tighten all parts prior to tightening with

wrench. Do not force parts together.

 Handle plated surfaces with care, being careful

not to scratch with tools.

 Wall mount faucets have a ½” I.P.S. female

flanged inlet.

 For easier assembly, you may purchase as an

accessory, the LKMK462 mounting kit (see
Figure 2).

Assemble Faucet to Backsplash

1. Apply teflon t ape or pipe joint compound to
supply line nipples.

2. Place nipples through holes in backsplash.

3. Assemble each flanged inlet to one nipple, then
the other.

4. Using the optional LKMK462, apply in order
behind the back-splash: rubber washer, washer,
lock nut and elbow (see Figure 2).

5. Thread flanged inlet loosely against wall or
backsplash.

1/2” IPS
Supply Line
Nipple

Escutcheon

Figure 1

Sink/Backsplash

1/2” IPS by 1/2”
Copper Sweat Elbow

Rubber

Washer

Nipple

Faucet Body

2” Offset

6. Carefully orient, mount and hand tighten the
faucet to the two flanges. Besure to include the
washers provided.

7. Use wrench to tighten flange against
backsplash. (Maintain alignment of faucet or
spout to sink while tightening).

8. Wrench tighten flanges to faucet body.

9. Make sure drain is attached and turn on water
supply - being sure to check for leaks. Wrench
tighten where needed.

Lock Nut

Page 2

Lock

Washer

1/2” Offset

Flanged Inlet

Figure 2

Faucet Body

A55483 (Rev. B - 9/10)