Elkay LKMY1041CR Installation manual

SAVE FOR CONSUMER

Includes:

INSTALLATION / OWNER’S MANUAL

Mystic - Pull-Out Kitchen Faucet

LKMY1041CR

LKMY1041NK
LKLFMY1041CR
LKLFMY1041NK

1

D

D

2

D

E

Tools:

3

D

B

2

C

C

1

C

13/16”

[20 mm]

1/2”

[13 mm]

13/16”

[21 mm]

[16 mm]

1

B

2

B

3

B

NOTE: these washers are not
used on this faucet model

5/8”

A

WARNING: please carefully read and properly follow the instructions for installation found in this manual.

STEPS:

321

A

Before inse rting the single lever grou p in the hole of
the sink, make sur e that the base gasket is proper ly

positio ned in its seat and that the  exible hoses are

well tighte ned to the body of the ta p.
Place th e single lever g roup in the hol e of the sink,
orienti ng the spout toward th e sink tank.

2

D

Attach the c ounterweight (D2) to the exib le hose
approxim ately 15- 3/4” [400 mm] from the connect ion

to the outle t pipe.

2

13/16”

[21 mm]

B

3

B

3

D

1

B

For counter top thicknesses less tha n 1/16” thi ck

use the  ange (B1), for all oth er inst allations use
the metal wa sher (B2).

Secure mounting hardware in place by tight ening

mounting n ut (B3).

54

E

Tighten t he shower (E) t o the hose inte rposing
the gasket (D3) and co nrm the hose can slide

smoothly t hrough the passag e hole.

2

C

13/16”

[20 mm]

1

D

1/2”

[13 mm]

Install th e check valve (C1) to the outlet hose w ith a
rubber was her (C2).

Secure wi th wrench.
Attach t he pull-down ho se to the bottom of the

check valv e with a rubber washe r (D1).

Secure wi th wrench.

1

C

6

5/8”

[16 mm]

Connect the exible hoses to the supply connect ions

with rubb er gaskets.
Secure wi th wrench.
Turn on the water an d check for leaks.

Red

Hot

Blue

Cold

CARTRIDGE REPLACEMENT

321

13/16”

[21 mm]

C

B

1/8”

[2,5 mm]

Before dis sassembling the f aucet be sure that the w ater supply is turne d off.

Remove t he nish cap (A), paying a ttention not to damage it . Remove the setscrew (B) with a 1/8” [2,5mm] hex w rench. Remove the handle (C). Lift the nishing rin g nut
(D) using the reference notch . Remove the indica tor ring (E). Unsc rew the cartri dge nut (F) then pu ll out the cart ridge (G). Put the new c artridge int o the body of the fau cet,
checkin g that the two cente ring pins enter into th e respective seat s (X) and that the gaske ts on the cartri dge are well positio ned.

Reassmbl e the handle followi ng the instructi ons in reverse order.

A

F

G

E

X

D

AERATOR CLEANING / REPLACING

1 2

Before rem oving the aerator ma ke sure that the faucet i s turned off.

If the suppl y is not uid unscrew ma nually the aerator- holder, remove the lte r without damaging a nd/or loosing the ga sket.
If the aerat or is clogged just r inse it with runnin g water. Do not use detergent s.

Reassemb le the aerator by follo wing the instruc tions in reverse ord er.