Elkay LKLFAV2031CR, LKAV2031CR Installation manual

SAVE FOR CONSUMER
Includes:
INSTALLATION / OWNER’S MANUAL
Avado - Pull-Down Kitchen Faucet
LKAV2031CR
LKAV2031NK LKLFAV2031CR LKLFAV2031NK
Tools:
1
D
D
2
C
C
1
C
2
D
3
D
B
13/16”
[20 mm]
1/2”
[13 mm]
13/16”
[21 mm]
E
1
B
2
B
3
B
NOTE: these washers are not used on this faucet model
5/8”
[16 mm]
A
WARNING: please carefully read and properly follow the instructions for installation found in this manual.
STEPS:
321
A
Before inse rting the single lever grou p in the hole of
the sink, make sur e that the base gasket is proper ly positio ned in its seat and that the  exible hoses are well tighte ned to the body of the ta p.
Place th e single lever g roup in the hol e of the sink,
orienti ng the spout toward th e sink tank.
4
2
D
Attach the c ounterweight (D2) to the exib le hose approxim ately 15- 3/4” [400 mm] from the connect ion to the outle t pipe.
2
13/16”
[21 mm]
B
3
B
1
B
For counter top thicknesses less tha n 1/16” thi ck
use the  ange (B1), for all oth er inst allations use the metal wa sher (B2). Secure mounting hardware in place by tight ening mounting n ut (B3).
5
3
D
E
Tighten t he shower (E) t o the hose inte rposing
the gasket (D3) and co nrm the hose can slide smoothly t hrough the passag e hole.
2
C
13/16”
[20 mm]
1
D
1/2”
[13 mm]
Install th e check valve (C1) to the outlet hose w ith a
rubber was her (C2). Secure wi th wrench. Attach t he pull-down ho se to the bottom of the check valv e with a rubber washe r (D1). Secure wi th wrench.
1
C
6
5/8”
[16 mm]
Connect the exible hoses to the supply connect ions with rubb er gaskets. Secure wi th wrench. Turn on the water an d check for leaks.
Red
Hot
Blue
Cold
CARTRIDGE REPLACEMENT
321
1-1/8”
[28 mm]
C
B
1/8”
[2,5 mm]
Before dis sassembling the f aucet be sure that the w ater supply is turne d off. Remove the n ish cap (A), paying atte ntion not to damage it . Remove the setscrew ( B) with a 1/8” [2,5mm] hex wre nch. Remove the handl e (C). Lift the nishing r ing nut (D) using the refe rence notch. Unscrew th e cartridge nut (E) the n pull out th e cartridge (F). Put the ne w cartridge into the bo dy of the faucet, checkin g that the two centering pi ns enter into th e respective seat s (X) and that the gasket s on the cartri dge are well positio ned. Reassmbl e the handle followi ng the instructi ons in reverse order.
A
E
F
X
D
AERATOR CLEANING / REPLACING
1 2
Before rem oving the aerator ma ke sure that the faucet i s turned off. If the suppl y is not uid unscrew ma nually the aerator- holder, remove the lte r without damaging a nd/or loosing the ga sket. If the aerat or is clogged just r inse it with runnin g water. Do not use detergent s. Reassemb le the aerator by follo wing the instruc tions in reverse ord er.
Loading...
+ 5 hidden pages