Elkay LKEC2012LS Installation manual

Important!

You choose the flow rate!

This faucet ships with an
eco-friendly 1.5GPM flow regulator

installed.

If you desire higher flow rate, a

2.2GPM flow regulator has also
been included in the box.

Switching the flow regulator is
simple! See the "Flow Regulator
Replacement" section for details.

INSTALLATION / OWNER'S MANUAL

Single Handle Bar Faucet

Model # LKEC2012

Groove joint pliers

OPTIONAL 2.2GPM FLOW
REGULATOR

Wrench

(2) 1/2 in Supply Lines

SAVE FOR CONSUMER

Screwdriver

Sealant Tape

Plumber's Putty

WARNING: Please carefully read and properly follow the instructions for installation found in this manual.

STEPS:

1

2

3

Shut off water supplies.Clean sink surface.
Place washer ② and flange ① on the sink
③.If you do not use flange,please use
escutcheon ④ and gasket ⑤ to replace
flange and washer.

Ø 1 3/8''

Ø35mm

4

5

1

4

1

2

3

Place faucet through the hole in top of
sink. From underside,assemble rubber

washer ①,metal washer ② and nut ③
onto long shank ④ and tighten nut ③.
Firmly tighten the nut ③ to metal washer
②. Do not overtighten.

2

1

From undernea th the sink,align block ①
and tabs ② on quick connects.Push quick
connect housing firmly upward and snap
onto receiving block.Pull down moderately
to ensure connection has been made. If it
is necessary to remove quick connect,
squeeze tabs on hose between index
finger and thumb, then pull down to
disconnect.

2

3

4

5

Make connections to water lines with 3/8"
female compression supply hoses ①.

If additional hose length is needed, attach

included 1/2" MIP thread adaptors ② to
supply hoses ①. Use 1/2" I.P.S. faucet
connections ③ or coupling nuts ⑤ with 3/8"
O.D.ball-nose riser ④ to make connections
to water lines. Use wrenche s to tighten
connections. Do not overtighten.

1

Important: after installation is completed,
turn on hot and cold water supplies.
Remove aerator ①. Turn faucet handle to
the warm position where it mixes hot and
cold water. Flush water lines for one
minute. Check for leaks.Retighten any
connections if necessary.Reinstall the
aerator tightly.