Elkay LKD2442C, LKDA2437C Installation manual
Replacement parts available
by visiting web site
www.elkayusa.com
ELKAY LIMITED LIFETIME FAUCET WARRANTY
ON RESIDENTIAL FAUCETS
Limited Lifetime Functional and
Finish Warranty
Elkay warrants to the original consumer purchaser that the Elkay faucet purchased will
be free from defects in material and workmanship for as long as the original consumer
purchaser owns the faucet. Elkay will, at its
option, supply replacement parts (or if no
longer available a comparable product) if the
faucet fails due to a defect in material or
workmanship. This warranty does not apply
in the event of product surface damage
caused by abuse, misuse or improper care
and maintenance. This warranty excludes
damage caused by harsh or abrasive cleaners
and/or materials. This warranty excludes all
industrial, commercial and business use,
whose purchasers are hereby extended a
limited lifetime on mechanical parts and 5
years on finish. Product replacement does
not include transportation cost or labor
installation cost. Elkay reserves the right to
examine product in question and its installation prior to replacement.
OTHER WARRANTY CONDITIONS
ON FAUCETS
Our warranty does not cover product failure
or damage caused by abusive treatment,
misuse, environmental factors, improper
care and cleaning, or damage due to handling or faulty installations. This warranty is
extended only to the original consumer purchaser of the product. This warranty does
not cover shipping costs, labor costs, or any
other charges for such items as installation
or replacement of the sink, diagnosis or
replacement of any faucet or component
part, or any other expense or loss.
How to Install a
Top Mount
Two-Handle Faucet
All incidental or consequential damages
are specifically excluded. No additional
warranties, express or implied are given.
Any implied warranty, including one of
merchantability or fitness for a particular
purpose, is limited to the duration of this
written warranty.
Some states do not allow the exclusion or
limitation of incidental or consequential
damages or limitations on how long an
implied warranty lasts, so the above limitations or exclusions may not apply to you.
This warranty gives you specific legal rights,
and you may also have other rights which
vary from state to state.
TO OBTAIN SERVICE
UNDER WARRANTY
1. Write to: Elkay
Attention: Consumer Services
2222 Camden Court
Oak Brook, IL 60523
2. Include a letter containing the following
information:
a. Date of purchase and installation
b. Description of nature of defect
c. Model number or description of model
and/or component part if possible.
Elkay
www.elkayusa.com
2222 Camden Court
Oak Brook, IL 60523
USA
©2013 Elkay
SAVE FOR CONSUMER
0000000999 (8/13)
ELKAY•2222 CAMDEN COURT•OAK BROOK, IL 60523 USA
Install Spray and Hose (if included)
1. Remove locknut and washer from sprayer base assembly and
place assembly in far right hole of sink deck. Reassemble washer
and locknut on shank from under sink. Tighten.
2. Insert hose through sprayer base assembly then route back up
through the center hole for the faucet. Thread hose onto faucet
and tighten.
Install Faucet
1. Be sure mounting surface is clean and dry. Apply plumbers
putty or silicon sealer to bottom of escutcheon gasket.
2. Place faucet shanks through holes in sink.
3. Fasten faucet to deck from underneath sink using washers and
nuts. Tighten.
4. Clean extra plumbers putty or silicone from around escutcheon.
5. Connect supply lines to faucet shanks and tighten.
6. Place washer on the waterway spout connector and thread spout
assembly by hand until snug.
7. Remove aerator from spout and Flush water lines to remove dirt
and sediment from water lines. Replace aerator.
Install Handles (if required)
1. Ensure cartridge (valve) is in the “off” position. (Fully counter
clockwise for Cold and Fully clockwise for Hot.)
2. Insert handle over cartridge stem
3. Insert alignment screw in handle hole towards back of sink. Screw
in only half way.
4. Place Red Temperature Indicator Ring in the top of the hot side
handle and the Blue ring in the top of the Cold side handle.
5. Place Logo part in top of both handles so logo can be read from
front of sink.
6. Thread handle set screw into each handle and tighten.
SET SCREW
LOGO
TEMPERATURE
INDICATOR
RING
ALIGNMENT
SCREW
HANDLE
HANDLE
INSTALL
CARTRIDGE/VALVE
CARTRIDGE NUT
SPOUT ASSEMBLY
DIVERTER
INSTALL
SPOUT
WASHER
SPRAY HEAD
HOSE GUIDE
WASHER
LOCK NUT
HOSE
Change Diverter Valve (If Side Sprayer Equipped)
1. From top of sink, Unscrew spout and pull upward to remove.
2. Unscrew waterway spout connector from main waterway (Wrench
flats provided).
3. Pull diverter valve out of waterway and replace with new diverter in
same orientation.
4. Thread waterway spout connector into main waterway and tighten.
5. Thread spout assembly on waterway and hand tighten.
Elkay recommends installation by a licensed plumber.
Loading...