Elkay LK6000LS Installation manual
Important!
You choose the flow rate!
This faucet ships with an
eco-friendly 1.5GPM flow regulator
installed.
If you desire higher flow rate, a
2.2GPM flow regulator has also
been included in the box.
Switching the flow regulator is
simple! See the "Flow Regulator
Replacement" section for details.
INSTALLATION / OWNER'S MANUAL
Single Handle Kitchen Faucet
Model # LK6000
Groove joint pliers Wrench
(2) 1/2 in Supply Lines
Screwdriver
SAVE FOR CONSUMER
OPTIONAL 2.2GPM FLOW
REGULATOR
Sealant Tape
Plumber's Putty
WARNING: Please carefully read and properly follow the instructions for installation found in this manual.
STEPS:
3-Ø 1 3/8" (Ø35mm)
1
Shut off water supplies.
Before installation, remove quick connect assembly (1)
from the free end of pullout hose.
If installing the faucet with the large escutcheon, begin
with step 2A. If installing the faucet with small
escutcheon, begin with step 3.
2
1
3
4
5
6
Retract pull-out hose (1) up through faucet body, until the
pull-out hose fitting is flush with the bottom of shank (2).
Do not pull hose fitting past the shank. Insert faucet body
through the hole in escutcheon.
Note: Do not feed the pull-out hose (1) back down
through the spout until step 4.
From underneath sink, hand tighten mounting nuts (3).
Install plastic washer (4) and metal washer (5) onto the
threaded mounting shank. Thread nut (6) onto mounting
shank. Do not overtighten.
Before installation, screw bolts to the large escutcheon.
Insert escutcheon assembly through the gasket and the
holes of the sink.
2
1
Ø 1 3/8" (Ø35mm)
3
4
5
Retract pull-out hose (1) up through faucet body, until
the pull-out hose fitting is flush with the bottom of shank
(2). Do not pull hose fitting past the shank. Insert faucet
body through the hole.
Note: Do not feed the pull-out hose (1) back down
through the spout until step 4.
Install plastic washer (3) and metal washer (4) onto the
threaded mounting shank. Thread nut (5) onto mounting
shank. Do not overtighten.
Loading...