Elkay LK3001CR Installation manual

Important!

You choose the flow rate!

This faucet ships with an
eco-friendly 1.5GPM flow regulator
installed.

If you desire higher flow rate, a

2.2GPM flow regulator has also

been included in the box.
Switching the flow regulator is

simple! See the "Flow Regulator
Replacement" section for details.

INSTALLATION / OWNER'S MANUAL

Single Handle Kitchen Faucet

Model # LK3000

Groove joint pliers

Wrench

(2) 1/2 in Supply Lines

Screwdriver

SAVE FOR CONSUMER

OPTIONAL 2.2GPM
AERATOR INSERT

Sealant Tape

Plumber's Putty

WARNING: Please carefully read and properly follow the instructions for installation found in this manual.

STEPS:

2-Ø1 3/8" (Ø35mm)

1
2

3

Shut off water supplies. Place spout
through mounting hole in sink.
Secure spout with rubber washer (1),
metal washer (2) and nut (3).

1

1

2

Place handle assembly through side
hole in sink. Secure handle assembly
with washer (1) and nut (2). Make
sure that the slot on nut is facing up.
Make sure handle is facing forward
and it swings equally in both
directions.

2

3

Attach the hose to the connection
beneath the faucet by aligning the tabs
on quick connectors. Push quick
connectors housing firmly upward and
snap onto receiving tube tabs. Pull
down moderately to ensure connection
has been made.
If it is necessary to remove the quick
connectors, squeeze tabs on hose
between index finger and thumb, then
pull down to disconnect.

Make connections to water lines. Use
1/2" I.P.S. faucet connections (1) or
use coupling nuts (3) with 3/8"
O.D.ball-nose riser(2).Use
wrenches to tighten connections.
Do not overtighten.

Important: After installation is
completed, remove aerator assembly.
Turn on hot and cold water supplies.
Turn handle to full open position for
one minute. Check for leaks.
Replace aerator.