Elkay LK2000CR Installation manual

INSTALLATION / OWNER'S MANUAL

Two Handle Laundry Faucet

Model # LK2000

WrenchGroove joint pliers

(2) 1/2 in Supply Lines

Screwdriver

SAVE FOR CONSUMER

OPTIONAL 2.2GPM AERATOR
ASSEMBLY

Sealant Tape

Plumber's Putty

WARNING: Please carefully read and properly follow the instructions for installation found in this manual.

STEPS:

3-Ø 7/8" (Ø22.2mm)

2

1

Shut off water supply at angle stop. Remove old
faucet.Clean sink surface in preparation for new
faucet.

2

3

Make connections to water lines. Use 1/2" IPS
faucet connections (1) or use coupling nuts (3)
with 3/8"O.D.ball-nose risers (2).
Use wrenches to tighten connections. Do not
overtighten.

1

Place gasket (1) on bottom of new faucet. Place
faucet through mounting holes in sink. Secure
faucet to sink using mounting nuts (2) provided.

Important: After installation is completed, remove
connector. Turn on water supply and allow both hot
and cold water to run for at least one minute each.
While water is running, check for leaks. Replace
connector.