Installation Instructions
ATTENTION INSTALLER:
1) ELKAY RECOMMENDS THAT UNDERMOUNT SINKS SHOULD BE INSTALLED BY A PROFESSIONAL
EXPERIENCED INSTALLER.
2) WARNING: TEMPLATE IS NOT INCLUDED. PLEASE VISIT ELKAYUSA.COM FOR SINK TEMPLATE.
MAKE SURE THE TEMPLATE YOU CHOOSE WILL GIVE YOU THE DESIRED INSTALLATION LOOK.
ELKAY’S TEMPLATES PROVIDE EITHER A 1/2" REVEAL OF THE SINK FLANGE OR 1/8" OVERHANG
OF THE COUNTERTOP OVER THE SINK BOWL OPENING. IT IS RECOM M ENDED THAT YOU
DISCUSS THIS WITH YOUR CUSTOMER AND AGREE THAT THIS FINISHED APPEARANCE IS THE
DESIRED EFFECT. ELKAY IS NOT RESPONSIBLE FOR IMPROPER SINK OR COUNTERTOP INSTALLATIONS. DUE TO THE AESTHETIC QUALITIES OF THE CONVERGING BOWL RADII, THE TEMPLATE
FURNISHED WITH EACH SINK PROVIDES THE ONLY OPENING RECOM MENDED FOR INSTALLATION OF ELKAY UNDERMOUNT SINKS. SEE ILLUSTRATIONS BELOW.
3) ELKAY UNDERMOUNT SINKS SHOULD ONLY BE FASTENED TO A SOLID SURFACE COUNTERTOP
(I.E. GRANITE/CORIAN®/SILESTONE®).
4) ELKAY IS NOT RESPONSIBLE FOR SINK OR COUNTERTOP IF DAMAGED DURING INSTALLATION.
5) METAL EDGES MAY BE SHARP – USE CAUTION WHEN HANDLING.
6) FOLLOW ALL LOCAL PLUMBING AND BUILDING CODES.
7) INSPECT SINK FOR DAMAGE PRIOR TO BEGINNING INSTALLATION.
I
NSTALLATION
1. Position template on countertop. Locate the
template front to rear, so that sink will not interfere with the cabinet.
2. Trace a line around the template. Cut along the
inside of this line to provide opening.
3. Locate and drill the mounting holes (following
the countertop manufacturer’s instructions) as
shown below. Holes should allow even spacing
of moun
ting brackets around the sink. Type of
fasteners to be as re commended by countertop
supplier.
COUNTERTOP RECESSED
APPROX. 1/2"
SILICONE CAULK
(NOT FURNISHED)
MOUNTING
CLIP: LKUCLIP8
(NOT FURNISHED)
FASTENER
(NOT FURNISHED)
1-1/8"
SINK
4. Fasten mounting brackets (optional accessory LKUCLIP8) to countertop loosely.
5. Using a good quality silicone caulk, apply a bead
evenly all around the top of the sink flanges.
6. Position and align sink over the countertop
opening. Press silicone onto countertop.
7. Tighten fasteners until mounting brackets ar
snug against sink.
8. Check alignment of sink to countertop opening.
9. Tighten down fasteners evenly. Be careful not to
overtighten. Remove excess silicone.
SILICONE CAULK
(NOT FURNISHED)
MOUNTING
CLIP: LKUCLIP8
(NOT FURNISHED)
FASTENER
(NOT FURNISHED)
SINK
COUNTERTOP
OVERHANG
e
1/2” SINK RIM REVEAL 1/8” COUNTERTOP OVERHANG
Installation Instructions
Suggestions for the Care and Cleaning of Sinks
made with CuVerro®Antimicrobial Copper
ELKAY SATIN FINISH
Elkay's original highlighted satin finish is produced by an abrasive
grinding operation which lends a uniform pattern of satin finish lines
to the metal surface. All exposed areas then undergo a series of
progressive machine and hand polishing ope
polishing that makes an Elkay satin luster finish so beautiful…and so
easy to clean and maintain.
rations. It is this careful
PROPER CARE AND USE
The use of CuVerro antimicrobial c opper does not replace standard
infection control procedures and good hygienic practices. Surface
must be cleaned and sanitized acc ording to standard practice. Health
care facilities must maintain antimicrobial copper surfaces
dance with infection control guidelines; users must continue to follow
all current infection control practices, including those practices related
to disinfection of environmental surfaces. Surface may be subject to
recontamination and the level of active bacteria at any particular time
will depend on the frequency and timing of recontamination and cleanliness of the surface (among ot her fact
In order for the surface to have proper antimicrobial effect, the
product must be cleaned and maintained according to the directions
included in this label. THIS PRODUCT MUST NOT BE WAXED,
PAINTED, LACQUERED, VARNISHED, OR OTHERWISE COATED.
Routine cleaning to remove dirt and filth is necessary for good sanitation and to assure the effective antibacterial performance of this
copper surface. Cle
care surfaces are permissible; the appropriate cleaning agent depends
on the type of soiling and the measure of sanitization required. Normal
tarnishing or wear of this product will not impair the antimicrobial
effectiveness of t he product. This product can not be used for any
direct food contact.
Purchaser is aware and informed that the Elkay sink b
is made up of a copper-nickel alloy. Some literature reports that
some persons may have allergic reactions when exposed to nic kelcontaining substances. Purchaser should insure that reasonable precautions are taken in this regard. Elkay and purchaser agree that
should a claim or litigation arise wherein a person is seeking damages
due to an alleged allergic reaction to these substa
chaser will indemnify, defend and hold harmless Elkay for any damages and the costs of litigation for any such claim.
aning agents typically used for traditional health-
ors).
in accor-
eing purchased
nces, that pur-
CLEANING
Any uncoated c opp er alloy surface is a “ living” finish. The surface has
been selected for healthcare applications because of its resistance to
corrosion and tarnishing.
Brushed surfaces reduce fingerprinting. Normal daily cleaning will
remove fingerprints. Howeve
time, or stains develop, there are several citric acid based water soluble
cleaners available, such as Wright’s
www.cuverro.com for additional information.
r, if surfaces are not cleaned for a long
®
Copper Cream. See
RECOMMENDATIONS
FOR PROPER MAINTENANCE
• Do…Rinse thoroughly after each use. “Thorough” rinsing can be
done by running water for a few minutes and rubbing the cleaned
area with a clean sponge.
• Do…Towel dry after each use to prevent mineral deposits from
building up on the surface of the sink.
• Do…Clean the surface to
disinfectants, frequency, etc.). Be sure to rub in the direction of the
satin finish grain lines. Antimicrobial copper alloys have been shown
to be an effective supplement to standard cleaning practices, but
are not intended to replace normal cleaning!
• Do…Use a cleaner that will not leave a wax film or coating on the
surface, so that cleaning will not interf
action of the surface.
• Do Not…Rub the sink across the satin finish lines. Scouring across
the satin finish lines can damage the original sink finish.
• Do Not…Allow soap or other household cleansers to dry on the
surface of t he sink. Most brands contain chemical additives which
will affect the original finish.
• Do N ot…Use a steel wool pad to clean your sink. If a more abra-
sive
product is needed, use a green Scotch Brite pad being sure to
rub in the direction of the satin finish grain lines. Steel wool pads
have a tendency to break apart and small partic les of steel can
become embedded in the surface of the sink. The steel particles will
rust and will give the appearance that the sink itself is rusting.
• Do N ot…Use with ammonia. Cleaners, caulks, and sealants con-
taining ammonia may affect the finish.
regular hospital protocols (i.e. appropriate
ere with the antimicrobial
SCRATCHES
Like many metallic surfaces, your antimicrobial copp er sink will
scratch. These are merely usage scratches and over time will blend
into t he overall finish of your sink with proper cleaning.
WATER QUALITY
The quality of your water can affect your sink’s appearance. If your
water has a high iron content, a brown surface stain can form on the
sink giving the appearance of rust. Additionally, in areas with a high
concentration of minerals, or with over-soften
may develop on the sink. To combat these problems, we suggest that
the sink be towel dried after use, and again, on a weekly basis, the
sink should be cleaned using a mild, non-abrasive cleaner.
ed water, a white film
ELKAY COMMERCIAL SINKS AND FAUCETS LIMITED WARRANTY
Elkay warrants commercial sink and faucet products to be free of defects in workmanship and materials for a period of 5 years from the date of
purchase. This warranty does not cover transportation or installation charges. Contact Elkay customer service (630-572-3192) for complete details
and conditions
Elkay
2222 Camden Court
Oak Brook, IL 60523
.
©2012 Elkay
Printed in U.S.A.
elkayusa.com
(Rev C. 10/12) 74180726