Elkay EDFPB114FPK Installation Manual
EDFPB114FP
Installation/Care/Use Manual
EDFPB114FPC
®
Swirlflo
Freeze Resistant Fount ain
Installer
T o assure you install this model easily and correctly , PLEASE READ THESE SIMPLE INSTRUCTIONS BEFORE ST ARTING THE INST ALLA TION. CHECK YOUR INST ALLA TION
FOR COMPLIANCE WITH PLUMBING , ELECTRICAL AND OTHER APPLICABLE CODES.
After installation, leave these instructions with the building owner for future reference. This
Freeze Resistant Fountain is shipped in two separate cartons. The second carton contains
the Freeze Resistant Package LKFRB1 that is installed on an interior heated wall. Refer to
the Freeze Resistant Package for the rough-in dimensions for installation.
IMPORTANT
ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SER VICE PERSON
IMPORTANT! INSTALLER PLEASE NOTE.
THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. T O WA TER
LINES IS A COMMON PROCEDURE. THIS GROUNDING MA Y BE IN THE BUILDING OR MA Y OCCUR A WA Y
FROM THE BUILDING . THIS GROUNDING CAN CAUSE ELECTRICAL FEEDBACK INTO A FOUNT AIN, CREA T ING AN ELECTROL YSIS WHICH CAUSES A MET ALLIC T ASTE OR AN INCREASE IN THE MET AL CONTENT
OF THE WA TER. THIS CONDITION IS A VOIDABLE BY USING THE PROPER MA TERIALS AS INDICA TED.
ANY DRAIN FITTINGS PROVIDED BY THE INST ALLER SHOULD BE MADE OF PLASTIC TO ELECTRICALL Y
ISOLA TE THE FOUNT AIN FROM THE BUILDING PLUMBING SYSTEM.
1/4" O.D. TUBE
WATER INLET
TO COOLER
FIG. 1
3/8" O.D. UNPLATED
COPPER TUBE CONNECT
COLD WATER SUPPLY
NOTE: WATER FLOW
DIRECTION
BUILDING WATER
INLET
SERVICE STOP
(NOT FURNISHED)
OPERA TION OF QUICK CONNECT FITTINGS
SIMPLY PUSH IN
TUBE TO ATTACH
TUBE IS
SECURED
IN POSITION
PUSH IN COLLET
TO RELEASE TUBE
PUSHING TUBE IN BEFORE
PULLING IT OUT HELPS TO
FIG. 2
98008C (REV . B - 4/06)
1
RELEASE TUBE
EDFPB114FP
7 1/4"
184mm
12"
305mm
MAX. WALL
THICKNESS
13 3/8"
339mm
2 5/8"
66mm
3 5/8"
91mm
EDFPB1 14FPC ROUGH-IN
16"
406mm
12"
305mm
MAX. WALL
18 3/8"
467mm
1 5/8"
41mm
3/8" (10mm) DIA HOLES (4)
FOR SECURING MOUNTING
PLATE TO STUDS
A
3/4"
19mm
THICKNESS
FINISHED FLOOR
27"
686mm
ADA
REQUIREMENT
33 15/16"
863mm
29 1/4"
743mm
28 3/4"
730mm
FIG. 3
8"
203mm
B
1/2"
13mm
5"
6"
127mm
LEGEND:
A = 7/8" (22mm) DIA. HOLE FOR W A TER SUPPL Y TUBE
B = 1-3/4" (44mm) DIA. HOLE FOR WASTE LINE
*Note: All dimensions are taken from the finished floor on the side of the wall
that the fountain is installed on.
152mm
25 3/8"
645mm
98008C (REV . B - 4/06)
2
Loading...