Elkay EDFP210C-B Installation Manual

EDFP210C*B EDFP214C*B EDFPVR214C*B EDFP217C*B

Installation/Care/Use Manual

Soft Sides™ Fountains with FLEXI-GUARD

®

EDFP210, EDFP214C

EDFP217C

Installer
T o assure you install this model easily and correctly ,
PLEASE READ THESE SIMPLE INSTRUCTIONS BEFORE ST ARTING THE
INST ALLATION. CHECK YOUR INST ALLA TION FOR COMPLIANCE WITH
PLUMBING , ELECTRICAL AND OTHER APPLICABLE CODES. After installation, leave
these instructions inside the fountain for future reference.

IMPORTANT

ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON

IMPORTANT! INSTALLER PLEASE NOTE.

THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO
WA TER LINES IS A COMMON PROCEDURE. THIS GROUNDING MA Y BE IN THE BUILDING OR MA Y
OCCUR A WA Y FROM THE BUILDING . THIS GROUNDING CAN CAUSE ELECTRICAL FEEDBACK
INTO A FOUNT AIN, CREA TING AN ELECTROL YSIS WHICH CAUSES A MET ALLIC T ASTE OR AN
INCREASE IN THE METAL CONTENT OF THE WATER. THIS CONDITION IS A VOIDABLE BY USING
THE PROPER MA TERIALS AS INDICA TED. ANY DRAIN FITTINGS PROVIDED BY THE INST ALLER
SHOULD BE MADE OF PLASTIC TO ELECTRICALL Y ISOLA TE THE FOUNT AIN FROM THE BUILDING
PLUMBING SYSTEM.

1/4" O.D. TUBE
WATER INLET
TO COOLER

3/8" O.D. UNPLATED
COPPER TUBE CONNECT
COLD WATER SUPPLY

NOTE: WATER FLOW

DIRECTION

BUILDING WATER
INLET

SERVICE STOP
(NOT FURNISHED)

FIG. 2FIG. 1

97156C (Rev. P - 8/07)

EDFP210C*B EDFP214C*B EDFPVR214C*B EDFP217C*B

EDFP210C, EDFP214C

C = 1-1/4" TRAP FURNISHED

D = 3/8" (10mm) DIA. HOLES FOR SECURING FOUNTAIN T O W ALL

FIG. 3

97156C (Rev. P - 8/07)

PAGE 2

LEGEND

A = RECOMMENDED W ATER SUPPLY LOCA TION 3/8 O.D. UNPLA TED

COPPER TUBE CONNECT STUBBED 1-1/2" (38mm) FROM WALL SHUT

OFF BY OTHERS

B = MODEL EDFP210C: RECOMMENDED LOCA TION FOR WASTE OUTLET

1-1/4" O.D. DRAIN STUBBED 1-3/8" (35mm) FROM THE WALL

MODEL EDFP214C: RECOMMENDED LOCA TION FOR WASTE OUTLET

1-1/4" O.D. DRAIN STUBBED 6-5/8" (168mm) FROM THE WALL