Elkay EDFP117C Installation Manual

MP86 Mounting Panel Instructions

For Use With The Swirlflo® Fountains

ELKA Y MANUF ACTURING COMPANY • 2222 CAMDEN COURT • OAK BROOK, IL 60521 • 630.574.8484 • TELEX:RCA 289243

FOR PARTS, CONT ACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.323.0620

FIG. 2

FINISHED FLOOR

FIG. 1

LEGEND: A = WATER INLET LOCA TION LEFT OR RIGHT SIDE. 3/8” O.D. TUBE CONNECT . B = FOUNTAIN W ASTE LOCATION LEFT OR RIGHT SIDE. W ASTE IS SHOWN IN WALL

BUT MAY BE BEHIND W ALL. 1-1/4” O.D. DRAIN (TRAP NOT FURNISHED).

C = FRAMING REQUIRED WHEN OPTIONAL AP-99 ACCESS PANEL IS USED. D = 3/8” (10mm) DIA. HOLES FOR SECURING MOUNTING PLATE TO STUD. E = NOTCH STUDS 1/8” (3mm) DEEP . MOUNTING PLA TE MUST BE FLUSH WITH STUDS

WHEN INSTALLED.

97202C

F = 5/16” (8mm) LAG SCREW OR EQUIV ALENT NOT FURNISHED.

NOTES:

1. WALL PLA TE MUST BE SUPPORTED SECUREL Y . ADD FIXTURE SUPPORT CARRIER IF

WALL WILL NOT PROVIDE ADEQUA TE SUPPORT .

2. FINISHED WALL MA TERIAL MUST BE NOTCHED TO ACCOMMODA TE LAG BOLT HEADS.

3. THREAD ROD INTO MOUNTING PLA TE BEFORE FINISHED WALL IS INST ALLED

4. WHEN USING MOUNTING P ANEL, MOUNTING STUDS SHOULD BE ADJUSTED TO

PROTRUDE 1” (25mm) FROM FINISHED WALL OR BACK P ANEL. SEE FIGURE 2.

5. LOCK THREADED ROD IN PLACE USING A 5/16-18 NUT ON THE BACK SIDE.

97202C

EDFP117C MOUNTING PANEL INSTRUCTIONS