Elkay DSE133224, DEMR233223, K125222, DD125224DF, DPA233224 Installation manual

INSTALLATION INSTRUCTIONS
1 Position sink upside down on countertop.
SINK
UNDER SIDE OF SINK
COUNTER TOP
DRAW OUTLINE AROUND SINK
2 Draw line 5/16” inside outline of sink.
OUTLINE OF SINK
COUNTER TOP
5/16 MINIMUM
COUNTER TOP
3 Cut on inside line. Cut straight front-to-back and left-to right.
4 Apply caulking compound around cutout on countertop top surface.
CAULKING COMPOUND
COUNTER TOP
5 Mount faucet and drain(s) in place on sink and tighten per manufacturer’s instructions.
6 Set sink in cutout.
7 Preassemble clamps, screws and plastic pads.
8 From underside – place clamp in center along each side and hand tighten to hold sink in place. Fasten balance of clamps along edges spaced approximately 3” from each end, and equally along front, back and sides.
For countertops thicker than 3/4”
up to 1-1/2”, Elkay recommends using LK364.
9 From the top – check seal between sink edge and countertop. Adjust clamps if necessary.
10 Lightly tighten clamps evenly with screw driver or socket wrench until sink is perfectly tight to countertop.
CAUTION: Do not over tighten.
Sink
DETAIL OF U-CHANNEL
Silicone Caulk (Not Furnished)
Clip
Screw (Optional: LK364)
Countertop
MAXIMUM CUTOUT SIZES SHOULD BE:
Cutout
Sink Size Cutout Size
33" x 22" 32-3/8" x 21-3/8" 1-1/2" 25" x 22" 24-3/8" x 21-3/8" 1-1/2" 17" x 21" 16-3/8" x 20-5/8" 1-1/2" 17" x 19" 16-3/8" x 18-3/8" 1-1/2" 15" x 15" 14-3/8" x 14-3/8" 1-1/2"
Corner Radius
Installation Instructions
Suggestions for the Care and Cleaning of your Elkay Stainless Sink
ELKAY SATIN FINISH
Elkay's original highlighted satin finish is produced by an abrasive grinding operation which lends a uniform pattern of satin finish lines to the metal surface. All exposed areas then undergo a series of progressive machine and hand polishing operations. It is this careful polishing that makes an Elkay satin luster finish so beautiful…and so easy to clean and maintain.
RECOMMENDED CLEANSERS
Elkay has tested general household cleansers to measure their effec­tiveness in cleaning stainless steel sinks. The cleansers consist of Bar Keeper’s Friend, Zud and Lawrence Right Work. Other cleansers, which are still effective, but less aggressive include Ajax, Comet, Shiny Sinks Plus, Luneta, Soft Scrub, Mr.Clean, Maas and Flitz. The non-abrasive formula is safe and effective for day to day cleaning. So to help maintain the beautiful finish of your stainless steel sink, use one of the cleansers that Elkay recommends.
most aggressive
RECOMMENDATIONS FOR PROPER MAINTENANCE
Do…Rinse thoroughly after each use. “Thorough” rinsing can be done by running water for a few minutes and rubbing the cleaned area with a clean sponge.
Do…Towel dry after each use to prevent mineral deposits from building upon the surface of the sink.
Do…Clean the sink once a week, being sure to rub in the direction of the satin finish grain lines, using an Elkay recommended cleanser.
Do Use an Elkay bottom grid or rinsing basket to “protect” the finish. Bottom grids and rinsing baskets can remain in the sink and will no
Do Not… Rub the sink across the satin finish lines. Scouring across the satin finish lines can damage the original sink finish.
Do Not… Allow soap or other household cleansers to dry on the surface of the sink. Most brands contain chemical additives which will affect the original finish.
Do Not… Use solutions of chlorine bleach and water in the sink. C and cleansers, are very aggress sink too long they can cause surface pitting.
Do Not… Use a steel wool pad to clean your sink. If a more abra- sive product is needed, use a green Scotch Brite pad being sure to rub in the direction of the satin finish grain lines. Steel wool pads
Elkay warrants to the original purchaser of an Elkay stainless steel sink that Elkay will, at its option, replace or repair, without charge, such product if it fails due to a man­ufacturing defect during normal residential use. Product replacement does not include transportation cost or labor installation cost. This warranty covers only stainless steel self-rimming drop-in sinks installed in a conventional countertop surface and stainless steel undermount sinks installed in a conventional solid surface countertop and applies
to residential installations only. Elkay reserves the right to examine product in question and its installation prior to replacement.
WASTE FITTINGS AND ACCESSORIES ARE NOT WARRANTED OTHER WARRANTY CONDITIONS ON SINKS
Our warranty does not cover product failure or damage caused by the use of optional Elkay accessories, abusive treatment, misuse, environmental factors, normal wear including dents and scratches, improper care and cleaning, use of aggressive and abrasive cleaners, damage due to handling or failure to follow the recommended procedures for installation, care and maintenance as detailed in the installation and care guide provided with every sink. This warranty is extended only to the original consumer purchaser of the product. This warranty does not cover shipping costs, labor costs, or any other charges for such items as installation or replacement of the sink, diagnosis or replacement of any faucet or component part, or any other expense or loss. This warranty does not cover obsolete, discontinued nor display products, whether such items are purchased at discount outlets and / or on-line or sold on clearance or close out.
t cause rusting or pitting.
hlorides, which are found in most soaps, detergents, bleaches,
ive to stainless steel. If left on the
ELKAY LIMITED SINK WARRANTY
have a tendency to break apart and small particles of steel can become embedded in the surface of the sink. The steel particles will rust and will give the appearance that the sink itself is rusting.
Do Not… Use rubber mats or dishpans in the sink. Leaving rubber mats or dishpans in the sink can lead to surface rust or possible pitting. However, if you insist on using mats or dishpans, please remove the mat after each use and rinse thoroughly.
Do Not… Leave wet sponges, cloths, or cleaning pads on the sink. This can lead to surface rust. Following these recommendations for the care and cleaning of your stainless steel sink will insure that it will provide you with many years of service.
CHLORIDES
Today, chlorides are found in most all soap, detergents, bleaches and cleansers; chlorides can be aggressive to stainless steel. However, chlorides are very water soluble. Therefore, THOROUGH RINSING of your sink after each use to remove any chloride residue and a weekly cleaning is all that is required to keep your sink looking bright and shiny.
SCRATCHES
Like many metallic surfaces, your stainless steel sink will scratch. These are merely usage scratches and overtime will blend into the overall finish o
f your sink with proper cleaning.
KNIVES
Y
our sink is designed to serve as many things but not as a cutting board or chopping block. This type of use will lead to deep scratches in the sink finish and will dully our knives. Elkay does offer various cutting boards which will provide an additional work area.
WATER QUALITY
The quality of your water can affect your sink’s appearance. If your water has a high iron content, a brown surface stain can form on the sink giving the appearance of rust. Additional concentration of minerals, or with over-softened water, a white film may develop on the sink. To combat these problems, we suggest that the sink be towel dried after use, and again, on a weekly basis, the sink should be cleaned using a recommended cleanser.
FOODS
Heavy salt concentration or foods containing high levels of salt should not be allowed to dry on the sink surface. Rinse your sink thoroughly after use.
All incidental or consequential damages are specifically excluded. No additional warranties, express or implied are given, including but not limited to, any implied warranty of merchantability or fitness for a par­ticular purpose.
Some states do not allow the exclusion or limitation of incidental or conse­q
uential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. The above protection will continue for 1 year.
TO OBTAIN SERVICE UNDER WARRANTY
1. Write to: Elkay Manufacturing Company Attention: Consumer Services 2222 Camden Court Oak Brook, IL 60523 2
. Include a letter containing the following information: a. Date of purchase and installation b
. Proof of Purchase (copy of original dated invoice) c. Description of nature of defect d. Model number or description of model and/or component part if possible.
ly, in areas with a high
Elkay
2222 Camden Court Oak Brook, IL 60523
©
2013 Elkay
Printed in U.S.A.
elkayusa.com
(Rev. E 06/13) 64180036
Loading...