ELK WK1 User Manual

STROBE W ALL MOUNT INST ALLA TION

A) IF YOUR INST ALLA TION IS ONTO A SINGLE OR

2-GANG BOX, REFER TO FIG . 1. USUALLY ,
THE BEST CENTERING AND FIT WILL COME
FROM INSTALLING THE ADAPTER PLA TE IN
THE POSITION SHOWN.

B) IF YOUR INSTALLATION IS ON A PLAIN WALL WITHOUT A

CONDUIT BOX, REFER TO THE CIRCLED INSET .

C) CONNECT THE RED (12V+) AND BLACK (-) WIRES FROM THE STROBE

TO A NON-PULSED “ALARM” OUTPUT OR “VIOLATION” OUTPUT.
(MOST PULSED OUTPUTS WILL ALSO OPERA TE THE STROBE,
BUT THE FLASH RATE WILL BE SLIGHTL Y ERRA TIC.)

1

ELK-WK1

WALL MOUNT KIT

FOR ELK-SL1 STROBE

A) CAREFULL Y ALIGN THE STROBE VERTICALL Y, USING A

3/16 HEX (ALLEN) WRENCH, TIGHTEN THE MOUNTING SCREW,
THEN SNAP THE WHITE PLASTIC COVER IN PLACE.

A) TWO ITEMS INCLUDED WITH THE STROBE KIT ARE

NOT USED WITH A STAND-ALONE WALL MOUNT
INSTALLATION:

i) THE SCREW RETAINER W ASHER IS NOT USED

AND SHOULD BE REMOVED.

2

B)

FOR “SINGLE WALL BOXES: THE LEFT MOST 1/4-20 HOLE
WILL PROVIDE BEST CENTERING.
FOR “2-GANG” BOXES: THE RIGHT HAND 1/4-20 HOLE WILL
PROVIDE BEST CENTERING.
FOR “NO BOX” WALL MOUNT: INST ALLER MAY SUBSTITUTE
A MOUNTING SCREW WHICH MATCHES THE PARTICULAR
SCREW ANCHOR.

ii)THE CLEAR PLASTIC WIRING GUIDE IS NOT

NEEDED BUT MA Y BE LEFT IN PLACE AND
SIMPL Y “STUFFED” INTO THE STROBE’S
WIRING CAVITY.

3

4

COMPLETED INSTALLA TION.

SPECIFICATIONS

1. OPERATING VOL T AGE: 12 Volt s D.C.

2. CURRENT DRAIN: APPROX. 140ma.

3. FLASH RATE: APPROX. 1 FLASH/SEC.

ELK PRODUCTS, INC.

PRINTED IN USA 05/02

PO Box 100 • Hildebran, NC 28637 • 828-397-4200 • 828-397-4415 FAX

http://www.elkproducts.com • email: [e-mail]