Elite Screens ZPM-RT User Manual

F. Wall box

ZPM-RT

Remote Control Kit for Spectrum2 Series

What’s included:

G. AAA Batteries

110”

A. B. Red+ Green -
IR Remote RF Remote C. 12V Trigger D. IR ey receiver

ZPM-RT Installation & Control Instructions1

1. Disconnect the 3 Way Control Switch from the Spectrum2 as shown below.

3 Way Control Switch

Screen

Rev1204-12-JA www.elitescreens.com 1

2. Connect the Wall Box (F) to the screen as shown below.

Wall box (F) Screen

ZPM-RT Installation & Control Instructions 2

Please consult a professonial installer for this procedure. Elite Screens is not responsible for faulty installations.

1. Cut the cable of both the Wall Box (H) and the attached Control Switch to expose the wires.

Cut Cable

Cut Cable

Wall Box (H)

2. Connect the wires from the screen to the Wall box (H) according to their specific color.

Purple Wire = Up

Orange Wire = Down

Yellow Wire = Common

Yellow & Green Wire = Ground

Purple Wire = Up

Orange Wire = Down

Yellow Wire = Common

Yellow & Green Wire = Ground

Rev1204-12-JA www.elitescreens.com 2