Elite Screens VMAX Tab-Tension Dual Series User Manual

Tab-tensioned Dual Format Electric Projection Screen

VMAX Tab-Tension Dual Series

User’s Guide

Important Safety & Warning Precautions

Make sure to read this user’s guide and follow the procedure below.

Caution: The Screen’s Black Top Drop is already set to its maximum drop distance. There is NO extra top Black

Drop in the roller. Please be aware of this. Any attempts to increase the top black drop will void your warranty
with Elite Screens. Unapproved changes or modifications (except for cutting the power cord for hardwire
installations) to this unit are prohibited and will void your warranty. For more information, please contact our
Technical Support Department at [phone] Ext. 604.

 Please retain this user’s guide for future reference.
 To avoid damaging the unit, do not use with any unauthorized accessories not recommended by the

manufacturer.

 Handle the unit carefully during transportation to avoid any damages.
 To ensure safe and reliable operation, direct connection to a properly grounded power source is

advised.

 The power outlet supplying power to the unit should be close to the unit and easily accessible.
 Do not install the unit on uneven or inclined surfaces.
 Do not place any heavy objects over the power cord.
 Position the power cord properly to avoid creating a trip obstacle.
 To avoid an electrical shock or fire due to a loose contact or short circuit, do not overload the power

cord.

 The internal & external parts of this unit are not end user serviceable. Do not attempt to disassemble

this unit by yourself. No one except authorized technicians can open and make repairs to this unit.

 Make sure the power source that this unit is connected to has a continuous power flow.
 If there is need to use an extension cord, make sure the cord has an equal rating as the appliance to

avoid over heat.

 Do not handle the power plug when your hands are wet or your feet are in contact with water.

Do not use this unit under the following circumstances:

 Disconnect the power cord under the conditions of heavy rain, wind thunder or lightning.
 Avoid direct sun light, rain shower and moisture.
 Keep away from fire sources and high temperature to prevent this device from overheating.
 Cut off the power supply first before transportation or maintenance.
 To avoid possible injury and/or an electric shock, do not attempt to use this screen if there is obvious

damage or if there are any evident broken parts.

Rev.062215-EA 1 www.elitescreens.com

Installation Warning

Red + Green -

E. 5-12v

trigger cable

A. IR Remote

B. RF Remote

C. 3-way wall

switch

D. IR eye

receiver

F. AAA batteries

The instructions provided in this user’s guide are for reference only. Regardless of the mounting method, the
screen should be securely supported so that vibrations or pulling on the viewing surface will not cause the
casing to become loose or fall. The installer must insure that proper mounting hardware and fasteners are
used to provide adequate strength suitable for the installation. Elite Screens is not liable for any faulty
installations. For vertical limit adjustment instructions, please contact our Technical Support Department at
[phone] Ext. 604.

Individual modifications to this product are prohibited and will void the warranty with the manufacturer.
Please contact Elite Screens Customer Service for any questions.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that the interference will not occur on a particular installation. If this
equipment causes harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures.

 Reorient or relocate the receiving antenna of the device which may be casing the interference.
 Increase the separation between the screen and the device’s receiver.
 Connect the equipment into a different power outlet other than the device.

Pre-Installation

1. Carefully unpack the screen.

2. Always handle the screen in a leveled position on a clean surface.

3. In order to protect the screen from exposure to stains, keep the screen out of contact with foreign

particles such as dust, sawdust, and/or liquids.

Accessories for VMAX Tab-Tension Dual Series

Please make sure all accessories listed below are included before proceeding.

Rev.062215-EA 2 www.elitescreens.com