Elite Screens Spectrum, VMAX2 Series, Plus4 Series, Spectrum Series User Manual

Rev. 082510-JA

www.elitescreens.com [e-mail]

Spectrum/VMAX2 Series

Electric/Motorized Projection Screen

User Guide

Rev. 082510-JA

www.elitescreens.com [e-mail]

Important safety and warning precautions

1. Be sure to read this user guide before use and follow the procedures below.

 Please retain this manual for future reference.
 To avoid any damage, do not use in conjunction with any accessories not recommended by the

manufacturer. Handle the device carefully during transportation to avoid damage.

 To ensure safe and reliable operation, direct connection to a properly grounded power source is

advised.

 The power outlet suppl ying power to the unit should be close to the unit and easily accessible.
 Do not install the device on uneven or inclined surfaces.
 Do not put heavy objects on the power cord and position it properly to avoid creating a trip obstacle.
 Never overload the power cord to prevent an electric shock or fire.
 Guard the device from any liquid or foreign objects to avoid electrical shock or fire due to loose

contact or short circuit.

 There are no user serviceable parts in the device. Do not attempt to disassemble this device by

yourself. No one except authorized technicians can open this device to make repairs.

 Make sure the power source this device is connected to has a continuous power flow.
 If there is a need to use an extension cord, make sure the cord has the same equal rating as the

appliance to avoid overheat.

 Do not handle the power plug when your hands are wet or your feet are in contact with water.

2. Do not use this device under the following circumstances:

 Disconnect the power cord under the conditions of heavy rain, wind, thunder or lighting.
 Avoid direct sunshine, rain shower or moisture.
 Keep away from fire sources and high temperature to prevent this device from overheating.
 Cut off the power supply first before transportation or maintenance.
 Fully disconnect from the power supply when screen is not in use for a long period of time, as should

be done with any other electric household appliance. .

 To avoid possible injury and/or an electric shock, do not attempt to use the screen if there is obvious damage or

if there are any evident broken parts

Rev. 082510-JA

www.elitescreens.com [e-mail]

Warning

Accessories for Spectrum and VM AX2

Bubble level

E ye receiver

(Optional for Spectrum)

When using your IR remote,
always be sure to point your

remote at the IR receiver.

2 x AAA Batteries

Wall box switch

Note: Contact your reseller for optional
accessories or visit shop.elitescreens.com
for accessories purchase.
(US and Canada only)

RF remote

(Optional for Spectrum)

IR remote

Red 12V Green 0V

5-12 volt trigger cable

(Optional for Spectrum)

12

12V trigger cable

Individual modifications to this product are prohibited and will void the warranty. Please contact Elite
Screens Customer Service for any questions.

NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures.

 Reorient or relocate the receiving antenna of the device which may be causing interference
 Increase the separation between the screen and the device’s receiver
 Connect the equipment into a different power outlet than the device