Elite Screens Manual SRM Series, M85XWS1-SRM, M99NWS1-SRM, M113NWS1-SRM, M84NWV-SRM User Manual

Manual SRM Series

Manual Pull-Down Projection Screen

USER’S GUIDE

Rev. 032410-JA

www.elitescreens.com [e-mail]

Back of end cap

Front view

Pre-installation

1. Carefully unpack the screen.

2. Always handle the screen in a leveled position on a clean surface.

INSTALLATION

Flush Wall Mounting

1. Mark the location of where the screen is to be installed for the pre-drilled hole.

2. After marking the area and drilling the hole, insert the proper screw into the drilled hole and leave

about 1/8” of an inch from the wall to mount the screen.

3. Mount your screen from the keyhole located on back of screen’s left and right end cap.

Ceiling Mounting (additional hardware required)

Optional installation using a chain to hang the screen from the ceiling.

1. You can also hang the screen on a ceiling by using a chain (not included) and hang it by the two loops

located on each end of the case.

Rev. 032410-JA

www.elitescreens.com [e-mail]

SCREEN OPERATION

Note: Always pull the screen down or let it up in a 90-degree vertical angle. Do not allow the screen to touch
the screen case when the screen goes up or comes down to avoid damaging the screen material.

1. Pull the screen down from the lanyard or from the handle only in a 90-degree angle. Do not attempt to pull
the screen down by the surface or touch the screen, as it will damage the screen and void the warranty.

Note: An internal auto-lock mechanism system will cause the screen to stop and lock on the position at
intervals.

2. If you want to the screen to retract back, simply pull the screen down more than 2 inches and retract the
screen back by quickly and smoothly releasing it up gently. The screen is equipped with a SLOW RETRACT

MECHANISM (SRM) which allows the screen to slowly retract without the need to hold on to the handle or
lanyard. Simply release the handle and the screen will retract by itself.

Note: Always release at a 90-degree angle and do not let go until the screen is entirely inside the case

If ever the screen feels stuck, keep in mind that the screen’s mechanism is new and needs to be run up/down

a few times to loosen up. If this happens, carefully with a little force yank the screen straight down to unlock
the screen.

Rev. 032410-JA

www.elitescreens.com [e-mail]