Elite Screens F84NWV, F100NWV, F84NWH, F100NWH, F60NWV User Manual

Elite ez Cinema Series

FOR MODELS: F60NWV / F72NWV / F84NWV / F100NWV /

MATTE WHITE

Portable Floor Pull-Up Screen

F84NWH / F100NWH

USER’S GUIDE

Rev. 1.0

PARTS IDENTIFICATION:

Front

Back

Rev. 1.0

Precautions:

Warning! Screen damage can result from product mishandling if the enclosed
precautions are not followed.

In accordance with practicing home fire safety and to avoid screen damage, do not
place the screen near or beside a fireplace or high temperature appliances such as a gas

stove, BBQ or heater. (Fig. 1)

Fig.1 Fig.2

Place the screen beyond the reach of children. (Fig.2)

Operational Instructions:

Installation:

The EZ-Cinema screen is designed to be used as an easy to operate portable screen for a variety of
presentation environments. Its design enables it to be versatile for use in either classroom, conference
room, home or patio presentations. When packed, the unit carries with ease and opens up for projection
presentations within seconds. As a general rule, portable projector screens should be installed in an area
free from wind and heat or open flame sources such as a heater, BBQ grill or fireworks display.

Extend the base feet:

Locate the base feet on the bottom of the box cover at each end and
rotate the base foot until it forms a right angle between the footboard
and the cover box.

Rev. 1.0

Open the box cover:

Unlatch the buckles on both ends of the box and open the box cover. Next, secure the box with one hand
while removing the support rod with your other hand.

Installing the support rod:

First, make sure that the hanging hook is pointing toward the front facing the same direction as the screen,
then insert the square end of the support rod into the support plate as shown below.

Support
Plate

Pull up the screen:

Hold the pull hook with one hand, pull the screen up gently and hang it on the bracket hook.

Vertical Adjustment:

First loosen the locking sleeve, and then hold the small support rod with the left hand so as to slowly raise
it upwards until the screen is fully stretched to the desired position.

Rev. 1.0

Adjusting the screen:

Hold the screen with the left hand when the screen has been stretched to the desired position, and then
rotate the locking sleeve clockwise with the right hand until the rod is properly locked into position.

Screen completely assembled

Rev. 1.0