Elite Screens ezFrame Plus User Manual

Elite ezFrame/Cinema235 &

Sable Frame Series

Fixed Frame Projection Screen

User’s Guide

Parts List

1. Frame Parts x 6 pcs (4 top/bottom frame pcs. + 2 side frame pcs)

2. Tension Rods x 6 pcs (4 top/bottomrods + 2 side rods)

3. Screen Material x 1 pc

4. Center joints x 2 pcs

5. Elbow Joints x4pcs

6. Wall brackets x2 – 3 pcs (depending on model/size)

7. Screws x 16 pcs

8. Center Support Bar x 1 – 2 pcs (depending on model/size)

9. Support joiner x 2 – 4 pcs (depending on model/size)

10. Fix Plates x 30 – 90 pcs (depending on model/size)

Note: Please make sure all parts are included in your package before proceeding to assemble your Elite
Screens fixed frame projection screen.

FRAME ASSEMBLY

1. Insert the center joint connector to the horizontal frame piece and then fasten it with 2 screws.

Rev.091912-JA

www.elitescreens.com [e-mail]

1

½ Long frame

Push

2. Insert the other horizontal frame piece to the center joint connector and then fasten it with 2 screws.

Please do not secure the screws completely until the frames pieces have been lined up correctly.

3. Insert both elbow joint connectors into the long horizontal frame (see fig.1)

Rev.091912-JA

www.elitescreens.com [e-mail]

2

Push

Push

( fig.2)

Insert the exposed ends of the joint connectors
into the short (vertical) frame and align the four
corners so that they meet at perfect right angles

4. Join all four frame parts together following the steps shown below. (fig.2)

5. After making sure that all four corners join at right angles to form a perfect rectangle, fasten the four angles

together by using the (x8) joint screws included.(see fig.3)

Rev.091912-JA

www.elitescreens.com [e-mail]

3