D I Y W a l l S e r i e s
P o r t a b l e R o l l o u t P r o j e c t i o n S c r e e n
U s e r ’ s G u i d e
The DIY Wall Projection Screen was designed to provide a simple portable solution to hang on an
indoor/outside wall, patio, tree or just about any surface you want to project on. When using outdoors, please
keep away from direct sunlight or rain to ensure longevity. The screen material can be cleaned with mild soap
and water. For more information about this product, please visit www.elitescreens.com/diywall
Installation:
1) Measure the distance between the two hooks which are located on the top support bar and install two screws
or nails in the area where the screen will be installed. Once the nails or screws are in place, hang the screen
by the wall hooks and carefully roll the screen down.
2) Next, measure distance of the top hook and bottom hook to determine the height required for the bottom nail
or screw installation. Once the bottom nails/screw supports are in place hang the bottom hooks to secure the
DIY Wall screen.
www.elitescreens.com
DIY Wall Series Dimensions Table
Diagonal Size
(Aspect Ratio)
Side Black
Masking
Border
(A4)
The listed measurements are for general reference only. Please contact Elite Screens to verify product design and
dimensions before attempting to integrate its products with any structural or furniture modification. Although a
manufacturer may offer product advice, it may be taken or disregarded at the integrator’s discretion. Elite Screens will not
be held responsible or be otherwise liable for faulty installations.
Note: Data Error may be ±1"
www.elitescreens.com